RE180PL2 Ryobi Router - Overview

This is a genuine manufacturer approved replacement brush. It is specially produced for Ryobi routers. Includes one (1) carbon brush with lead wire, spring and a metal holder attached. Please note, most tools use two brushes. It is recommended to replace both brushes at the same time to ensure top performance. Replacing this carbon brush...Read more is a simple task that should only require a screwdriver to complete this job. • First make sure the tool is unplugged • Remove the brush caps • Remove the old brush • Secure the new brush • Reassemble and test your tool

This is an authentic Ryobi replacement part, sourced from the original manufacturer for use with routers. The plastic brush cap is commonly used to provide access to the brushes through the router's housing. This brush cap is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine replacement part sourced from the original manufacturer for use with routers. The metal spring fits into the bearing housing and is used to provide compression for the spindle shaft lock pin. This item is available as an individual replacement part, please see illustrated diagram for associative parts.

This part has been sourced from the original manufacturer to be used with routers from Ridgid. The clear plastic chip shield attaches to the base assembly. This part is used to guide the direction of the wood chips while providing a view of the router bit and cutting area. This item is sold as an individual replacement part.

This is an genuine OEM sourced replacement part used on routers. This part provides a grip for holding a bit in a tool. It is made out of metal and is sold individually. This collet is for using bits with 1/4" arbors only. Due to prolonged, heavy use a collet adapter may need to be replaced eventually. To replace this item you would nee...Read mored to use a Wrench. • First you would need to remove the collet nut • Once the nut is removed you can remove the old collet adapter • Place a new one in place • Tighten the collet nut back in place and your unit is ready to use 1/4" bits