RDG350AW Haier Dryer - Overview

Diagrams for RDG350AW

See every part. Know exactly what you need.

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
DRYER DOOR LATCH – Part Number: WE10X27377
No Longer Available
DRYER DOOR LATCH
Part #WE10X27377
DRYER DOOR LOCK MOTOR & SWITCH ASSEMBLY – Part Number: WE10X27373
No Longer Available
DRYER CONTROL BOARD – Part Number: WE19X27356
No Longer Available
DRYER CONTROL BOARD
Part #WE19X27356
PIPE - EXHAUST – Part Number: WD-5255-73
$10.55
Special Order
PIPE - EXHAUST
Part #WD-5255-73
BLADE – Part Number: WD-0550-01
No Longer Available
BLADE
Part #WD-0550-01
BRACKET – Part Number: WD-0850-23
$3.99
Special Order
BRACKET
Part #WD-0850-23
SCREW – Part Number: WD-6150-145
$4.36
Special Order
SCREW
Part #WD-6150-145
SENSOR - TEMP – Part Number: WD-6250-11
$80.63
Special Order
SENSOR - TEMP
Part #WD-6250-11
VALVE - GAS Assembly – Part Number: WD-7800-105
$189.72
Special Order
VALVE - GAS Assembly
Part #WD-7800-105
DRYER IDLER ASSEMBLY – Part Number: WE02X27388
No Longer Available
DRYER IDLER ASSEMBLY
Part #WE02X27388
Door Switch – Part Number: WE10X27374
No Longer Available
Door Switch
Part #WE10X27374
TAPPING SCREW – Part Number: WH02X26155
No Longer Available
TAPPING SCREW
Part #WH02X26155
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
unit would not run at all but would turn on
5 of 5 people found this instruction helpful.
  • Stanley from Cooper City, FL
  • Easy
  • 30 - 60 mins
  • Nutdriver, Screw drivers
They sent the wrong part even though I gave the unit model number and part number of the part.I described the part and gave the name used by the manufacture on the schematic from the back of the unit. The second person I spoke with to reorder the correct part took more time in understanding that a temp limiter is not the same as a temp se nsor. The part is located on the inside back wall of the dryer behind the drum. It all had to come apart to get to it but was very easy even without the service manual.Unplug the unit. Remove the 4 screws on the back that lock down the top and pop off the top prying against the spring clips, move it out of the way but remember that its still connected by wires on the inside of the back. disconnect the 2 wires going to the door switch. Remove the two screws holding the front panel on located on the top. Pull up on the panel lifting it off of the spade brackets. Reach in down below and remove the belt from the pulley and drum. Pull up on the drum about 1" and the drum will be free. remove the drum. In the upper right hand corner is where you will see the temp limiter. Remove the 2 screws and unplug the wires. Assembly is the reverse order except to install the belt remove the access panel on the lower left corner of the back of the unit to gain access to the belt for installation....
Was this helpful?
Thank you for voting!