RAFTV630 (Type 0) DeVilbiss Compressor - Overview

1 remove cover
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on the head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws

Actually don't like using Torx bits because they are hard to center deep in the channel. I had misplaced these forcing me to order replacements.
My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called AGC-408 by craftsman.