Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
DANIEL
July 5, 2023
dishwasher drains and fills normally between cycles but leaves the dishwasher full of water when the last (drying cycle) is finished.
Also, control panel makes clicking each time the washer is opened and then closed...
For model number PLD4460REC
Hello Daniel, thank you for reaching out. According to our research, the clicking is due to the relays on the control board. We would recommend checking the control board, part number PS2582629, to fix the issue. If any of the relays on the control board is faulty, they will not do the proper functioning. We hope this solves your problem!
Hi Dianne,
Thank you for your question. If you are looking to clean food deposits inside of your dishwasher, try using vinegar. Pour at least 3 cups of vinegar on the bottom of the dishwasher and run the dishwasher on the longest cycle. Make sure to run the hot water in the sink for a few minutes to make sure it is good and hot before using the dishwasher. We hope this helps! If you have any questions, please let us know.
Was this helpful?
Thank you for voting!
Marilynne
May 7, 2022
I have lost my rinse dispenser cap. will any cap fit?
For model number PLD4460REC
Hello Marilynne, thank you for writing. Yes, we have a part PS421128 that is compatible. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
Disconnect from power Unscrewed 4 phillips screws from top of outer door. Unscrewed 2 screws each siide of door. Lower outer door section drops away. Note wiring sequence on dispenser, then disconnect wires. Unscrew 6 screws on dispenser and lift dispenser out.
Place new dispenser in place (note orientation), ann fasten in place with screws, remembering to replace wire retainer on left lower screw. Reconnect wires to dispenser correctly. Slide lower outer door over tabs and secure with the 4 side screws. Ensure lower door is up under control panel and secure with the 4 top screws.
Fill dispenser with detergent, reconnect power and test run while enjoying a cup of tea in celebration of a job well done..
The only difficultpart was to figure out how to remove the stainless cover from the door. Seems it slides upwards after screws are removed. After that it is self explainatory and goes back together in 5 minutes.
After turning of the power to dishwasher, I opened the door took of the two bottom screws on both sides of door. Closed the door and front panel just slide off. Then I took a picture of the dispenser to make use I could figure out how to put the wiring back together. Removed the six screws holding it in place and popped the dispenser out. Easy .. popped new dispenser in and lightly put all six screws back in ,wired it back up after checking my photo. Closed the door ,slid front panel back on opened the door put the 4 screws back in that hold the front panel .Turned power back on and Boom!! All done.. Not bad for a girl...