This OEM ice and water filter fits side-by-side and bottom-freezer GE models. The most common reason you would need to change this part is if you have never updated your model and it is no longer filt...
This is the replacement pantry flip lid cover for your refrigerator. It is made of clear and white plastic and is approximately 30 inches in width and 6 inches in length. The pantry flip lid cover is ...
This is a replacement spring pin for French door-style refrigerators. This part is made of white plastic and is approximately ½ an inch in length. If the mullion that keeps the doors closed is not wor...
This part is the replacement French door hinge for your refrigerator. It is made of white plastic and is approximately 1 ¼ inch by 1 inch. The French door hinge can also be known as the flipper hinge....
Assembly CASE-ICE ROUTE
This dispenser ice chute door and funnel assembly is for refrigerators.
Dispenser ice chute door and funnel assembly opens to let ice through when dispensing into a glass ...
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
$382.17
Special Order
Questions And Answers for PFSS6SKXDSS
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple.
First, I have to say I live in the next state over, and I recieved the parts the next day. Yeah! OK, I removed the adjacent drawers *and the removable lower storage shelves on the doors for clearance*. Taking out the broken lid is easy. The new one is a tight fit. The right side has a raised pad on the pivot point, but the left one does not. I worked the peg (pivot point) in on the right side and slowly and carefully pushed the stationary plastic left side in slightly(and sprung the lid slightly) to get enough clearance to get in the left peg without breaking the new lid pivot. While doing this, one has to make sure the shelf immediately behind the lid is in place since there are support tabs located on it, and you will have to rework the thing if you don't get them to mate on the installation.
