This oven temperature sensor is designed to accurately measure the internal temperature of the oven cavity and relay that information to the appliance’s electronic control system for precise heat regu...
$199.26
In Stock
Order within the next 4 hrs and your part ships today!
This potentiometer is a replacement electrical control component used to adjust variable settings. It is commonly replaced when adjustments become erratic or unresponsive.
$178.83
In Stock
Order within the next 4 hrs and your part ships today!
This holder secures components or tubing in place to maintain proper alignment. Designed for durability, it supports stable operation and system organization.
$46.19
In Stock
Order within the next 4 hrs and your part ships today!
Order within the next 4 hrs and your part ships today!
Questions And Answers for PD366BS
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bill
September 13, 2022
I need 4 rubber feet for the stove grate. They measure 3/8” diameter
For model number PD366BS
Hello bill, Thank you for contacting us. We have researched the model you have provided and have found the Feet are only sold as part of the Grate. Thank you for your inquiry, good luck with this repair!
Remove slide racks from oven. At the back right corner of oven unscrew heat sensor probe. Access rear of range. Remove screws holding back panel. Find wire from temperature probe where it passes through back wall of over and unclip it pulling probe wire and probe out back of oven. From the inside of oven, push chopstick through hole probe wire was routed through, to find hole in back wall of oven. Once chopstick is visible from back of oven, with chopstick enlarge hole through visible insulation. This is the opening the new probe wire needs to be routed through. From inside oven push new wire, using chopstick, through this hole and reattach wire at back of oven using the plastic clip on the wire. From inside oven screw probe to back of oven wall, reattach outside panel to back of oven, turn gas back on, plug range back in, check oven operates, and push range back in place, reinstall racks. You may have to remove oven door if you have trouble reaching to the back of the oven to access the probe. YouTube videos are easy to find showing how to do that.
