PCC601LB Porter Cable Cordless Drill - Overview

This special screw is used to secure the chuck on electric drills. Over time especially if not secured correctly the threads of the screw may wear down eventually requiring replacement to safely secure the chuck. It is an authentic replacement hardware that is supplied directly from original tool manufacturer. This durable metal Torx screw is sold individually.

This item is a genuine DeWalt replacement part that is intended to be used with cordless drills and drivers. The bit clip can be used as a direct replacement of the original clip that would have been installed on a new drill. The clip snaps onto the side of drill's housing and is used to store frequently used drill bits. This item is priced as a single replacement part.

This is an OEM part sourced directly from the manufacturer. The switch assembly is found in a Porter Cable drill/driver. This part is a complete assembly, including a high-quality plastic trigger switch with plastic housing, metal connectors, and metal wires with flexible plastic coating. The switch is used to activate the machine. You will require a screwdriver when replacing this item.

This is an authentic Porter Cable replacement part that has been sourced from the original manufacturer to be used with drill/drivers. The chuck is used as a vice that fastens and holds the drill and driver bits. A screw driver is needed to install this part, please note the screw that secures the chuck is reverse threaded. The chuck is sold individually.

The actuator is made out of plastic. This is available individually. It is a genuine replacement part sourced from the original manufacturer for use with drills made by Porter Cable. When replacing this item a screwdriver might be required during the installation process. It will require replacing if it becomes broken.