PC60TAG (Type 1) Porter Cable Angle Grinder - Overview

This is an authentic replacement part manufactured for use with angle grinders. The side handle is used to provide a better grip on the tool and is threaded to fit onto either side of the grinder. Tools are not required to install this handle and the side handle is sold individually.

This replacement wrench is a genuine OEM approved part that is used with Dewalt, Black and Decker and Porter Cable agnle grinders. It is used to tighten or remove the outer flange which secures the grinding wheel. Please note this durable metal wrench is sold individually.

This is an original replacement part manufactured for use with angle grinders. The special metal flange sits above the grinding wheel, and provides space between the wheel and guard. This inner flange is sold individually.

This item is available as an individual replacement part. The guard is made of metal and attaches to the inner flange. A screwdriver might be helpful during the installation of this part. It will need to be replaced if it breaks. This genuine item is supplied by the original equipment manufacturer for use with Porter Cable grinders.

This replacement brush set is sourced directly from original equipment manufacturer and it is designed for use with angle grinders. Over time brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. This assembly includes two (2) carbon brushes with lead wires attached. Please...Read more note brush boxes are sold separately. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove screws from the housing • Separate housing to gain access to the brushes • Remove old brushes and secure the new ones in place • Re-assemble and test the tool

This item is sold individually. The brush box is made out of plastic and metal. It may require a screwdriver during installation. This part may become broken and will need to be replaced. It is an OEM Porter Cable part directly sourced from the manufacturer for use in grinders.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with angle grinders from Bostitch and Porter Cable. The switch fits inside the main housing and is used to relay electricity from the power cord to the motor assembly. A screwdriver and needle nose pliers may be needed to instal this item.

This replacement guard assembly is an authentic OEM part designed for Porter Cable angle grinders. It is used to direct dust and trimmings away from the user. This guard is made out of metal and it is sold individually. Replacing this guard is a simple task that does not require any tools. The guard is pre-adjusted to the diameter of the...Read more gear case hub at the factory. If, after a period of time, the guard becomes loose, tighten the adjusting screw with latch in the closed position and guard installed on the tool.