PC600JS (Type 1) Porter Cable Jig Saw - Overview

This is a replacement part directly sourced from the manufacturer for use in drills, hammers, grinders, sanders, jigsaws, and trimmers made by DeWALT, Porter Cable, Black & Decker, and Bostitch. It connects to the power cord and is made out of metal. This part is extremely small and will need to be replaced if it becomes lost or if it breaks. The terminal is sold individually.

This is an original DeWALT replacement part. The rip fence is found on jig saws. This is an optional accessory made of metal, which comes with a spring and a plastic adjusting knob. It is used to hold the material for cutting, to make easy straight cuts. No tools are required when replacing this item. Simply remove the old part and insert the new one in its place.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

It is a genuine OEM brush ring assembly that is specially designed for DeWALT, Black and Decker and Porter Cable jig saws. As the armature rotates inside the motor housing, electrical current is transferred through carbon brushes. Excessively worn brushes can result in visible arcing, decreased performance, power fluctuations or a total l...Read moreoss of power to the motor. To ensure the proper replacement procedure, refer to the owner's manual and the parts diagrams for your model. Note, one durable carbon brush with an attached lead wire and a spring is included. A screwdriver will be needed to take apart and reassemble the housing when performing this repair. It is advised to replace both brushes at the same time to ensure an even wear.

This is a genuine OEM sourced replacement screw that is specially produced for use with Black and Decker saws. It is generally used to secure the blade clamp to the shaft. This part is made from durable metal and it is sold individually. You will need a torx screwdriver to tighten or loosen this screw.

This authentic item is supplied directly from the original equipment manufacturer for use with Bostitch and Porter Cable jig saws. It is an identical replacement for a missing or a damaged blade support assembly that was installed on a new unit. Check the owner's manual and the appropriate diagrams for your model for the exact location an...Read mored the correct application of this component. Keep in mind this high-quality blade support assembly is made of durable metal and is sold individually.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Poter Cable jig saws and electric drills. When plugged in, the power cord transfers power to the unit. This part is made of flexible plastic and metal, it is also sold individually. For installation, you will need a screwdriver, and a pair of needle nose pliers to aid you.