PAFC430 (Type 0) DeVilbiss Compressor - Overview
Sections of the PAFC430
[Viewing 2 of 2]
Keep searches simple, eg. "belt" or "pump".
KIT VALVE REPLACEMEN
PartSelect #: PS12518149
Manufacturer #: KK-4315
Introducing Craftsman's high-quality relief valve. The vale is intricately designed to regulate and control pressure in your Craftsman product effortlessly. Made with superior materials for longevity ...
$69.71
Special Order
Nut
PartSelect #: PS9868378
Manufacturer #: 038738-00
This is a genuine replacement part manufactured for use with outdoor power equipment and air compressors. This nut is used to fasten various part assemblies on a range of different products. This nut ...
$7.44
Special Order
BOLT .375-16X2.25 UN
PartSelect #: PS12513336
Manufacturer #: CAC-60
This is an authentic replacement part, sourced from the original manufacturer for use with generators and air compressors. The shoulder bolt is used with several different types of equipment and the a...
No Longer Available
DRAIN VALVE
PartSelect #: PS12508562
Manufacturer #: N286039
When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where ...
$12.20
In Stock
Common Symptoms of the PAFC430
[Viewing 2 of 2]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The air was bypassing the compressor gaskets and cylinder wall was worn out
1 remove cover
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on the head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
2 unhook air line to tank
3 remove head bolts
4 remove intake from head
5 remove flywheel bolt to free up pump piston
6 remove screw on top of piston to change out gasket
7 remove the cylinder sleeve install piston from the top
8 reassemble piston rod end and the flywheel
9 on the head cover are two gaskets one on top and one on the bottom head
10 insert intake piece and bolt the head cover back in place
11 reinstall the air line and unit cover and secure with three cover screws
Parts Used:
-
Charles from GARRISON, TX
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Socket set
18 of 24 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!