P50 Bostitch Nailer - Overview

This part is an OEM from Bostitch. Compatible with several stapling pliers, the retaining core case ring is sold individually. The metal ring helps to secure the bushing and pin. A pair of needle nose pliers are required for the proper installation.

This is an original Bostitch replacement part manufactured for use with plier staplers. The compression spring is used to provide tension on the lock pin that secures the top guide assembly for the magazine. This compression spring is sold individually.

This is a Genuine Manufacturer Approved replacement part used on specific Bostitch Nailers. This is a Rubber Ring and it is sold individually. O-rings are designed to withstand thousands of pounds of pressure by creating a seal between two or more parts. Over time O-Rings will damage and should be inspected periodically. If parts are showing signs of wear they should be replaced.

This is a genuine manufacturer-sourced part that is specially made for Bostitch pneumatic pliers. The purpose of this bumper is to keep the piston from hitting the bottom of the cylinder and damaging it. Because this part gets so much abuse it has a tendency to crack and fall apart eventually requiring a replacement. Keep in mind this hig...Read moreh-quality component is made of durable rubber and is sold individually. Please make sure to check the diagrams of your model for the correct location and application of this bumper.

This is the special roll that supports and guides the extension spring in the magazine. Over time it may stretch, get damaged or lost eventually requiring a replacement. Make sure to refer to the appropriate diagrams for your model to ensure the correct repair procedure. Note, it is made of high-quality plastic and is sold as an individua...Read morel component. It is an authentic item that is supplied by the original equipment manufacturer for Bostitch pneumatic pliers.

This is an authentic Bostitch replacement part manufactured for use with pneumatic pliers. The pusher is used with the magazine to move staples forward. This pusher is available as an individual replacement part, please see model diagram for associative parts.

This is a genuine replacement part that is supplied directly from the original equipment manufacturer for use with Bostitch pneumatic pliers. It is one of the special pins for the lock pin block, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This magazine spring is an OEM direct from Bostitich. Compatible with the P50 Pneumatic Plier, the metal spring is fitted onto the base of the housing, securing the top guide assembly and magazine. A flat head screwdriver and a pair of pliers are often needed for the removal and replacement. The magazine spring is sold individually.