If your gas oven is failing to heat or not reaching the proper temperature, the most common culprit is a malfunctioning igniter. This bake igniter is designed for use in gas ovens and ranges, where it...
This oven temperature sensor is designed to accurately measure the internal temperature of the oven cavity and relay that information to the appliance’s electronic control system for precise heat regu...
Restore your oven’s performance with this control board fixing kit. It comes with everything you need to replace or secure the electronic control board—the part that manages temperature and cooking se...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Melinda
November 15, 2024
Thermador 30” Range gas leak.
Have replaced the regulator and the Venturi’s had to be replaced when drilled out.
Leak seems to be at Venturi locations when valve knobs are Off.
For model number P304CS
Hello Melinda, thank you for writing in. A gas leak may indicate a broken Gas Valve PS8713513 or the Gas Tube PS8723218. We hope this helps.
Remove slide racks from oven. At the back right corner of oven unscrew heat sensor probe. Access rear of range. Remove screws holding back panel. Find wire from temperature probe where it passes through back wall of over and unclip it pulling probe wire and probe out back of oven. From the inside of oven, push chopstick through hole probe wire was routed through, to find hole in back wall of oven. Once chopstick is visible from back of oven, with chopstick enlarge hole through visible insulation. This is the opening the new probe wire needs to be routed through. From inside oven push new wire, using chopstick, through this hole and reattach wire at back of oven using the plastic clip on the wire. From inside oven screw probe to back of oven wall, reattach outside panel to back of oven, turn gas back on, plug range back in, check oven operates, and push range back in place, reinstall racks. You may have to remove oven door if you have trouble reaching to the back of the oven to access the probe. YouTube videos are easy to find showing how to do that.
