N88WWB Bostitch Nailer - Overview
Diagrams for N88WWB
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Nut,Tee
Part #149747
Cap End,Magazine
Part #116563
Arm,Upper Contact
Part #108228
Seal,Cover Exhaust
Part #116961
Washer,Plain M5
Part #116965
Nut,Hfn,M8X1.25
Part #103859
O-Ring Repair Kit
Part #N88ORK
It is a genuine repair it which is supplied by the original equipment manufacturer. These parts are designed for use with Bostitch nailers. Over time parts will wear out and they may begin to fail eventually requiring replacements to ensure your tool functions properly. This kit includes all the recommended parts to be replaced when repai...Read morering your nailer. Refer to the owner's manual and the appropriate diagrams for your model to ensure the correct repair procedure. A screwdriver and pliers may be needed to perform this repair.
Read less
PIN-SPIRAL M3X30
Part #100298
It is a genuine manufacturer-supplied component which is made for Bostitch nailers and staplers. This is a special spiral pin that is utilized to secure the trigger. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. To ensure the proper repair procedure, refer to the appropriate diagram fo...Read morer your model. The spiral pin is made of durable metal and is sold as an individual item. You may need pliers to replace it.
Read less
SPRING-COMPRESSION
Part #100387
This compression spring is an OEM direct from Bostitch. The metal spring is compatible with many stapler and nailer tools. This item is fitted within the trigger valve kit of the device. The spring is the mechanism for the trigger to move back in place. Although this part is sold individually, it can also be found in the SEQ6 Kit. A small hammer and a hex key are helpful in the repair.
PIN-SPECIAL
Part #121407
This part is available as an individual replacement. The special pin attaches to the magazine and is made of metal. A set of pliers might be helpful during the installation of this item. It will need to be replaced if it becomes broken. This is a genuine OEM sourced part which is specially designed for use with Bostitch nailers.
SCREW-SOC HD. CAP M5
Part #MSC5080-20
SCREW-SHCS-M4X0.70X1
Part #MSC4070-12
It is an authentic item that is supplied directly from the original equipment manufacturer for use with Bostitch nailers. This replacement screw is a standard hardware which has multiple applications depending on the model of your unit, please make sure to refer to appropriate diagrams for correct location and use of this item. It is made of durable metal and it is sold individually.