N59FN Bostitch Nailer - Overview

Diagrams for N59FN

See every part. Know exactly what you need.

Page A

Parts for the N59FN

Pin, Spring .138 X 1.18

Part #UB3817

Label-Warning

Part #159911

Grip,Handle

Part #107490

Washer

Part #MPW6

Check Seal

Part #N50034

This is a genuine manufacturer-sourced part which is made for Bostitch nailers and staplers. It helps to distribute the pressure evenly and provide a tight seal between connected components. Over time check seal may wear out, become brittle and begin to crack eventually requiring a replacement. Make sure to check the appropriate diagrams ...Read more

Read less

Cap Magazine

Part #N60002

Foot Tip

Part #N60013

This item is an authentic Bostitch replacement part that has been sourced to be used with pneumatic nailers. The foot tip attaches to the foot trip and is used to provide a softer surface to the trip to prevent marring the material being fastened. This item is available as an individual replacement part.

Bumper, Top

Part #T50002

This replacement bumper is a genuine OEM sourced item that is specially made for Bostitch nailers and staplers. The purpose of this part is to keep the piston from hitting the bottom of the cylinder and damaging it. Because this part get so much abuse over time it will begin to fall apart eventually requiring replacement. This item is mad...Read more

Read less

LUBE (2CC)

Part #100653

$7.44

PIN-SPIRAL M3X30

Part #100298

It is a genuine manufacturer-supplied component which is made for Bostitch nailers and staplers. This is a special spiral pin that is utilized to secure the trigger. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. To ensure the proper repair procedure, refer to the appropriate diagram fo...Read more

Read less

$7.44

SPRING-COMPRESSION

Part #100387

This compression spring is an OEM direct from Bostitch. The metal spring is compatible with many stapler and nailer tools. This item is fitted within the trigger valve kit of the device. The spring is the mechanism for the trigger to move back in place. Although this part is sold individually, it can also be found in the SEQ6 Kit. A small hammer and a hex key are helpful in the repair.

$7.44

SCREW-SOC HD. CAP M5

Part #MSC5080-20

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

would not fire nails

10 of 15 people found this instruction helpful.

Richard from Bogalusa, LA
A Bit Difficult
30 - 60 mins
Pliers, Screw drivers

remove 2 Philips head screws, drive out drift pins with drill bit. Remove TVA6 replace with new TVA6 making sure TVA6 is completely seated and slots are aligned with drift pin holes! Drive in drift pins. Replace trigger and screws.
This did not solve the problem as suggested by Parts select.
Replaced Head Valve Seal...Problem re ... Read more

Read less

Was this helpful?