This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.
This is a replacement clutch assembly or cam kit for your washer. The clutch assembly is mounted on the drive shaft on the bottom of your washer. You may need to replace the clutch assembly if the spl...
This part changes the transmission from agitation to spin mode. This actuator is for washers.
Actuator shifts the splutch and monitors the position of the splutch.
Ask our experts a question about this model and we'll get back to you as soon as possible!
6 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Todd
January 7, 2020
Why doesn,t my washer spin it's not the belt i cked it lmk thank u
For model number MVWX700XL1
Hello Todd and thank you for writing.
As it is not the belt, it certainly sounds like it could be a faulty shift actuator PS11747977 and/or drive pulley PS10057144, you should check for signs of damage, and replace if necessary. We hope this helps. Please contact us anytime if you require further assistance.
can the impeller be replaced with an agitator assembly
For model number MVWX700XL1
Hi William,
Thank you for your question. There is no agitator listed for your washer. A washplate is used to circulate the wash load through the water. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Pat
November 29, 2023
Makes a terrible noise when spinning.
For model number MVWX700XL1
Hello Pat, thank you for contacting us. According to our research, we would recommend checking the drive belt for any damage. If this does not help, then the issue is most probably with the transmission, part number PS12347614. It drives the agitator and spins the basket in the washer. We hope this solves your problem!
How do you open the lid to replaces latch assembly
For model number MVWX700XL1
Hi Robert, Thank you for the question. Here is a link to our video on how to replace the lid lock. It should be of some help. Good luck with the repair!
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
A detailed Service Technician Service Manual is hidden inside the machine on the front panel. It is hidden by the bleach dispenser input. It gives a list of fault codes and instructions for calibration after repair, resetting fault codes, and a manual test mode for stepping the machine through each mode on command. The Tachometer failed which would not let the machine come up to maximum spin speed. The tachometer is part of the solenoid actuator that shifts the transmission. It is not specifically called out in the manual. Any failure causes the lid lock light to blink which gives the appearance of a lid lock failure
The instructions that came with the part were worthless. Essentially, unplug, put in new part, plug it back in. I spent a considerable amount of time on the internet and finally found a video showing how to open the top. Unlike other models, it is held down by clamps in the back rather than clips in the front. Once finding this information the installation was simple. Remove the clamps and the back of the console, slide the top forward and lift, remove and replace the lock and reassemble. You don't even have to remove the hoses.