This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
$16.07
In Stock
Order within the next 6 hrs and your part ships today!
This lid hinge is a genuine OEM replacement part for your washing machine. This hinge is for the left side of your lid, although it is a good idea to replace btoh hinges at once. The hinge holds up th...
$32.29
In Stock
Order within the next 6 hrs and your part ships today!
This is the hose that tells your appliance if your tub is at the desired water level.
$79.22
In Stock
Order within the next 6 hrs and your part ships today!
Questions And Answers for MVWB835DC0
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Charles
October 18, 2021
Error e2 and f5 after sensing and before lid lock
For model number MVWB835DC0
Hello Charles, Thank you for your inquiry. This error code indicates that the door is not locking properly because there may be an obstruction in the lid lock area or the lid lock is not working. Check for any obstructions in the lid lock area, and if there are not, test the lid lock with a multimeter to see if it has continuity. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. We hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Stacy
December 12, 2023
Washer is extremely loud when spinning. Is this a barring going out?
For model number MVWB835DC0
Hello Stacy, thank you for the question. We would recommend checking the slider kit, part number PS10060062, to fix the issue. We hope this helps!
Removed two screws on back of lid to raise top removed tub one bolt and one spanernut pulled tub lowered top reinstalled screws laid washer down to get to bottom of washer unplugged wiring removed four bolts pulled gear box and motor removed motor from gear box installed motor on new gear box reassemble washer
The valve is a 4 solenoid valve, which has Temp. sensor molded into the valve body mixer center outlet. No mention of it in the troubleshooting. it has a 2 pin plug. it was shorted zero ohms. New one measure open infinity. I also purchased the control module as the troubleshooting said to if solenoid checked good which all 4 read 1310 ohms , i purchased and replaced control module, no help. the guide is outdated for these new high tech washers. If this happens again. I will just unplug the 2 pin plug on bottom of valve assembly. By the way the 2 clips that hold the washer top in place are very difficult to remove and re install.