First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix .
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
Found instruction on internet, 1. Remove anit-tampering screws with punch and hammer 2. Remove the rest of the screws 3. Removed cover 4. Remove burned out bulb and installed new one 5. INstalled cover 6. Installed screws including the anti tampering onces 7. Op tested unit. Wife is happy.
.gif "SUPPLEMENTAL INFORMATION Diagram and Parts List for Maytag Microwave")
