Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY availab...
This pump has 2 ports. This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
This is a replacement lid switch actuating cam for your washer. The cam is located on the underside of the washer lid, near the hinge. The cam actuates the lid switch, so your washer knows the lid is ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Anita
December 24, 2019
The washer quit when i just opened the lid. Why
For model number MAV7000AWW
Hi Anita, thank you for your question. Your appliance is supposed to stop when you open the lid. The door lock controls that. It is so the drum is not spinning while the lid is open. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Anita
February 21, 2020
It takes 30 min to fill my machine with hot water. Once the hot water did not stop.
For model number MAV7000AWW
Hello Anita,
Thank you for your question. The part you will want to look at is your water inlet valve. It is responsible for running the water into your appliance. If it is taking too long, this would be the ideal starting point to check. We hope this helps you.
1 person found this helpful.
Was this helpful?
Thank you for voting!
LAURA
February 25, 2020
Washer does not drain and spin except in delicate cycle
For model number MAV7000AWW
Hello, Thank you for your question. You will want to check the cycle switch. That could be the issue. We hope this helps.
Was this helpful?
Thank you for voting!
Mark
November 20, 2023
2 part...While in the spin cycle it is very loud while spinning and when it stops it makes a squilling sound. Also it has a small leak from the bottom.
For model number MAV7000AWW
Hi Mark, thank you for contacting us. Based on our understanding, the issue is with the drain pump, part number PS11741799. We would suggest checking the drain pump to fix the issue. Good luck with your repair!
Lay washer on front, removed belt. Removed center pulley with thrust bearing (pulley was worn on upper end, against thrust bearing, thrust bearing was worn also). Installed new thrust bearing & pulley kit. Cleaned & lubed slots that motor insulators slide in, installed new belt.
Unlug the AC cord,open the top from the front it snaps open with a little force and hinges on the back, remove the 2 screws on the front cover and take it off, tip the washer and remove the belt, take off the pump hose from the back (I removed the back cover also) and the little hose going to the basket. Remove the 6 springs and lift the complete drum out of the waser and turn it upside down. You can see the plastic snubber ring that is worn, loosen the 6 screws just enough to get the old ring out and the new one in. WARNING (DO NOT TAKE THE SCREWS ALL THE WAY OUT OR THE BRAKE ASSEMBLY WILL RELEASE AND A SPECIAL TOOL IS NEEDED TO PUT IT BACK) Install the new ring, tighten the screws and put the tub back in connecting everything back up and use the 6 new springs. It really isn't that hard to do.