MAH2440BGW Maytag Washer - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
I leaned on the door while open and it broke off!!
Removed hinge and all screws holding two halves together with glass between them put glass in new parts and replaced all screws hinge fits in there also
installed back on washer and away we went....
installed back on washer and away we went....
Parts Used:
-
Raymond from Fort Myers, FL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
36 of 65 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Main sping wore through Spring support bracket
In this model the 2 main springs hang from a bracket built into the top of the machines frame. For some reason one of the pring was installed without the protective plastic grommet (called the guide spring washer). The handened spring eventually wore through the softer metal bracket due to the vibration of the washer.
The purchsed plastic part fit into the bracket so firlmy that even with part of the bracket wore away it appears to be still strong wnough to support the weight of the tub. It has made it through 10 loads so far and it still working well.
Getting at the spring was easy but lifting the tub was heavy. Thanks - $4 part saved a $1000 washer.
The purchsed plastic part fit into the bracket so firlmy that even with part of the bracket wore away it appears to be still strong wnough to support the weight of the tub. It has made it through 10 loads so far and it still working well.
Getting at the spring was easy but lifting the tub was heavy. Thanks - $4 part saved a $1000 washer.
Parts Used:
-
Paul from Green Bay, WI, WI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
6 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
A friend had leaned a little on the washer door, and the 10 + year old plastic broke.
Phillips screwdriver is only tool needed. There are about 14 screws around the perimeter, and my hand got tired, so I ended up getting my power driver to finish. Cleaned up all the surfaces while it was apart.
Parts Used:
-
Kurt from Grants Pass, OR
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
2 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Water leak from draw assy
Undo screws two at the back, take the lid off disconect the pipes to the assy,a little tight for room if you have larger hands.Pipes have spring clamps. Undo screws holding the aasy, in front behind trim and screws at the top.This is the 5th time I have replaced this part the water lines clog up so there for water runs all over.
Parts Used:
-
Dennis from Oxnard, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!