Designed for efficient ice production, this ice maker assembly includes the ice mold and control unit that work together to freeze and release ice. Water enters through the inlet valve and is held in ...
$364.78
In Stock
Order within the next 1 hr and 39 mins and your part ships today!
Is your refrigerator not cooling as it should? Our genuine LG DC Motor could be the solution you're seeking. Acting as the heart of your refrigerator, this crucial component ensures your appliance kee...
Is your LG Refrigerators ice dispenser giving you trouble? It could be that the Dispenser Ice Chute Door DC Motor needs a replacement. This motor is an important gadget that allows the ice door on you...
$99.18
In Stock
Order within the next 1 hr and 39 mins and your part ships today!
If your fridge isn’t making ice like it used to, the gasket on the ice bank door might be the problem. This replacement part helps keep warm air out so your ice stays solid and your fridge runs effici...
$132.70
In Stock
Order within the next 1 hr and 39 mins and your part ships today!
Shut off water supply. Disconnect main supply line. Remove rear lower panel on back of refrigerator. Remove all tubing clamps on back. Disconnect leaking tubing from water supply valve. Remove water filter and unscrew/remove water filter housing. Replace tubing - connect to water filter housing then to water supply valve. Reconnect filter housing and filter. Reinstall lower panel, then main water supply line, then all tubing clamps. Turn water back on and check for leaks after discarding several glasses of water to fill filter. Job complete!
For this model the ice maker is very easy to replace. All it takes is a phillips head screwdriver. There are two wire connections you have to unplug. Easy out easy in. You do not have to disconnect the water line, just make sure the line is lined up correctly when you reinstall the new icemaker. It seems to take approximately 8 hours before you start getting ice again. If you have this same model, you already know this ice maker is very slow in making ice and is not able to keep up with daily usage of ice for a household of 3.
The heavy work is moving the fridge, then take off the lower plans. Use a bowel or cup for screws and the water line connector spacers so you don't loos them. undo connections holding water line, including the bottom brakes for the solenoid. Reuse the spring around the lower waterline to prevent external wear on the line.
NOTE: remove the waterline connector spacers and save! NOTE: you must compress (not pull) the connect to then pull the waterline out of the connectors. NOTE: You must also remove the water filter and housing inside the fridge but this is easy. MOTE: Test the line for leaks by turning on the water and then using the door water. The filter will need to refill so it may take a minute before water comes up. This line only have pressure when the door water is used or the ice maker needs to make ice.
After replacing the line, test the line for leaks by using the door water so the solenoid fills the lines
