This v-shaped idler pulley belt is for washing machines that use three belts and that are loaded in the front. Made by Frigidaire, this belt is 46-5/8 inches long and 1/2 an inch wide. Use it for your...
This v-shaped high speed spin belt is for washing machines that use three belts and that are loaded in the front. Made by Frigidaire, this belt is 53-3/8 inches long and 1/2 an inch wide. Use it for y...
This v-shaped drive belt is for washing machines that use three belts and that are loaded in the front. Made by Frigidaire, this belt is 41-1/2 inches long and 3/8 of an inch wide. Use it for your Fri...
$24.01
Special Order
Questions And Answers for LT150JXV1
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
First I removed the top panel held by four screws at rear of panel, pulling the panel foward and up. Then disconnected the power and water connections. Then I removed the two screws holding the flow valve to the washer rear panel,pulled the valve foward ,removed the two electric connectors, pinched the water clamp with pliers and removed the water connection to the valve. Then replaced with the new valve followed the above steps in reverse order, finishing up by re placing the water connections and power. Then checked fo proper replacenent and leaks before replacing top panel.
Checked problem on-line and discovered it was the water inlet valve. Matched the part on part select. Com. Finding the part was very easy. Part select had a grid behind the picture to help determine the size and pictures from all sides. Removing the old part, matching it, and replacement took a total of 30 minutes. I now have clean clothes.
After moving machine to an area that allowed easy access to the unit, disconnected the water supply hoses from the inlet valve. Removed the two screws that keep the back in place, removed the clips that keep the top in place, moved the top over far enough to get the valve out. Removed the screw that keeps the inlet valve in place, disconnected the power supply to the valve, Pulled valve out in order to remove the water outlet hose. Repalced with new vale, and reversed order to install. Works just fine now.
