This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
This gas range oven igniter is compatible with various models of LG gas ranges. It is made up of the igniter element, wire harness, connector and mounting bracket. The igniter is responsible for gener...
If your range’s display is dim, blank, or not showing the right info, this LED module could be the fix. It lights up the control panel so you can see cooking settings, temperatures, and error messages...
Restore your oven’s performance with this gas valve. It controls gas flow to the burners for even heat and safe operation. If your oven won’t light or flames are uneven, this part may be the fix. Turn...
If your cooktop grates are cracked or wobbly, this replacement grille can help. It gives your pots and pans a stable surface and protects the burners underneath. It’s built tough to handle heat and ev...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Kavita
January 2, 2025
I need burner caps for the two front burners and back left burner kindly help with parts number, thank u. Model number LSGL5831F
For model number LSGL5831F
Hi Kavita, Thank you for reaching out. The Left Front Cap is listed as PartSelect Number PS16223957. The Right Front Cap is PartSelect Number PS16223961 and the Left Rear Cap is PartSelect Number PS16223956. Thank you for the inquiry, good luck with the repair!
Go onto youtube, such as https://www.youtube.com/watch?v=-ITkrwhDNMQ and watch similar videos for DYI. The process is very similar to other models.
Once the door is removed, place oven door on a towel or soft place so it does not scratch the door. Unscrew the screws and make sure you notice where each screw goes, so you know the process of where each screw goes when you re-assemble.
Once the inner cover is removed, remove the insulation, too so you don't damage it. Use Wet/Dry Shop Vac to clean the shattered glass. (WORD OF ADVICE: I did not remove the insulation and the suction of the Shop Vac removed part of the insulation, so now instead of a quick turn around repair turns into a few weeks repair, because the insulation is on back order 10-14 days from the supplier. DON"T MAKE THE SAME MISTAKE!)
Once the glass has been removed, the new inner glass is replaced, begin by re-assemble the oven door with the correct screws and attached the oven door to the range.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
Remove oven bottoms Removed burners Remove igniters Pull out oven removed back disconnect wiring Installed new parts on burner made wiring hook ups Installed oven back and oven bottoms Tested and both work Took so long because I’m 75 years old Thanks for the proper parts
