LSDL6336D (00) LG Range - Overview
Sections of the LSDL6336D
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Temperature Sensor
PartSelect #: PS11732697
Manufacturer #: EBG61305805
This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
$59.35
In Stock
Power Transformer Assembly
PartSelect #: PS16732632
Manufacturer #: EBJ64465501
The spark module controls the spark for lighting the cooktop surface burners.
$65.95
In Stock
HEATER,SHEATH
PartSelect #: PS12590568
Manufacturer #: MEE62865003
This sheathed heater assembly delivers consistent, controlled heat required for proper appliance operation. The protective outer sheath supports efficient heat transfer while safeguarding internal com...
$133.59
In Stock
VALVE ASSEMBLY,GAS
PartSelect #: PS12115016
Manufacturer #: AJU74852805
This gas valve assembly regulates the flow of gas to ensure safe, consistent burner operation. By precisely opening and closing based on control input, it supports reliable ignition and stable flame p...
$64.85
Special Order
Common Symptoms of the LSDL6336D
[Viewing 5 of 5]Little to no heat when baking
Fixed by
these parts
these parts
Show All
Oven not heating evenly
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Oven is too hot
Fixed by
these parts
these parts
Show All
Gas igniter glows, but will not light
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Convection Fan stopped working, would spin but not continuously on its own
Unplugged oven electric and turned gas off. Removed all back covers from the unit. Removed the cover on the inside covering the burner and fan in the back of the convection oven. Removed the nut securing the fan to motor shaft with helper holding the motor. Removed the three electrical wires attached to motor, making note where they go. Removed screws mounting the motor to oven. Removed motor cooling fan and shaft spacer from old motor. Fit in same orientation on new motor. Replace all parts in reverse order, restore gas and electric, turn on and test.
Parts Used:
-
Barry from PIERRE, SD
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers
16 of 24 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!