Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t difficult and should t...
The Water filter reduces contaminants such a s lead, iron, and chlorine from drinking water. Replace every 6 months or 200 gallons for best performance.
This part must be installed by a licensed and trained LG technician that is able to perform a software update, which is required for the installation of this compressor. Part number CJT30000002 is nee...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Jose
August 21, 2023
Doesn’t cycle off refrigerator too cold
For model number LSC22991ST
Hi Jose, thank you for getting in touch. We suggest you take a close look at door gasket to check whether the door is closing properly. If this is not the issue, we would recommend you checking your refrigerator defrost sensor, part number PS8751162. It monitors the temperature of the evaporator coil and sends the temperature reading to the electronic control board. We hope this helps.
This repair was easy. The ice maker assembly is basically a plug and play unit that requires first removing the ice bucket as described inside the freezer door. Next, remove several screws the support the unit, then gently lifting the ice maker assembly out, just far enough to access the 2 electrical plugs that operate the unit. Carefully unplug the old unit and remove it. Next, plug the new unit and then reverse the disassembly process. I could have done this in 10 minutes had I not been careful not to break anything. No special tools are required.
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
I paid for the expedited shipping and they sent me a cheap knockoff attempt at the part that had the wrong size hole. So they refunded me the money I paid for the part but not the shipping, and then I crushed the part they sent me with a hammer and threw it away.
