This OEM filter measures 2.5 inches deep, 12.5 inches high, 5 inches wide and roughly 1.5 lbs. It is recommended to replace this filter every six months or 300 gallons, whichever comes first. If you n...
This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ...
This part is the replacement water line for your refrigerator. It is a long plastic tube, which is 5/16 of an inch in diameter. If your refrigerator is leaking, or if it will not dispense water or ice...
Meet the LG Lower Door Hinge Assembly: your perfect solution for a smoothly functioning fridge door. This is a genuine OEM product, conceived and made by LG itself, so you can be fully confident of it...
This heated ice chute door helps prevent ice buildup and sticking by gently warming the chute opening during dispensing. Designed for smooth, reliable ice delivery, it restores proper operation when i...
This part is the replacement crisper pan slide rail for your refrigerator. It is made of white plastic and is approximately 13 inches by 2 inches. The crisper drawer will slide in and out along this r...
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting. Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards. The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.
1. Remove the filter - 1 screw at top of filter and pull-out. 2. Use crescent wrench to push down at tube inlet and pull tube out. 3. Remove bottom screen from refrigerator. 4. Use crescent wrench to push down on water inlet and pull out tube. 5. Route new line on back of refrigerator. 6. Install is the reverse of removal. Thanks.
