Order within the next 12 hrs and your part ships today!
Questions And Answers for LRGL5823S
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Melissa
July 7, 2023
I need the conversion kit to trasnsfer the stove from gas to propane can I order this here
For model number LRGL5823S
Hi Melissa, thank you for getting in touch. The LP conversion kit compatible with your model is part number PS16222236. We hope that helps!
looking for an extra oven rack and can't seem to locate one on this site
For model number LRGL5823S
Hi Christine, thank you for the question. The part you are looking for is the oven rack, part number PS16224466. If you need help placing an order, customer service is open 7 days a week!
Hi, The serial Number for my stove is as follows 107MMXN0C026
Model# LRGL5823S /01
I'm looking for controller board and the corresponding LG Range PCB Display Assembly controller circuit board for this model.
Any help would be appreciated.
Thank you for your attention.
Jose.
For model number LRGL5823S
Hi Jose, thank you for your question! The main control board is part number PS16223749. The display control board is part number PS16223754. We hope that helps!
Go onto youtube, such as https://www.youtube.com/watch?v=-ITkrwhDNMQ and watch similar videos for DYI. The process is very similar to other models.
Once the door is removed, place oven door on a towel or soft place so it does not scratch the door. Unscrew the screws and make sure you notice where each screw goes, so you know the process of where each screw goes when you re-assemble.
Once the inner cover is removed, remove the insulation, too so you don't damage it. Use Wet/Dry Shop Vac to clean the shattered glass. (WORD OF ADVICE: I did not remove the insulation and the suction of the Shop Vac removed part of the insulation, so now instead of a quick turn around repair turns into a few weeks repair, because the insulation is on back order 10-14 days from the supplier. DON"T MAKE THE SAME MISTAKE!)
Once the glass has been removed, the new inner glass is replaced, begin by re-assemble the oven door with the correct screws and attached the oven door to the range.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
As soon as my husband put it in the oven, the very thin prongs broke. There was no guard on either side of the prongs for protection like the one that had been in there. Very costly to us of $185 with no fix. Very disappointed in that ignitor. It would have been an easy fix. Had replaced one previously but it only lasted 6 months. Now we have a new stove