This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
This gas range oven igniter is compatible with various models of LG gas ranges. It is made up of the igniter element, wire harness, connector and mounting bracket. The igniter is responsible for gener...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bill
July 6, 2024
What does a F3 code mean on my oven display board
For model number LRG4113ST
Hello Bill, thanks for asking us. The F3 error indicates there is an open sensor. You will need to reset the unit to close the sensor. First, make sure the range is off and cut the power at the circuit breaker for 1-2 minutes. Then turn the breaker back on and it should reset the range and the sensor. If this does not help, the sensor may need to be replaced. We hope this helps and good luck with your repair!
Unplugged oven electric and turned gas off. Removed all back covers from the unit. Removed the cover on the inside covering the burner and fan in the back of the convection oven. Removed the nut securing the fan to motor shaft with helper holding the motor. Removed the three electrical wires attached to motor, making note where they go. Removed screws mounting the motor to oven. Removed motor cooling fan and shaft spacer from old motor. Fit in same orientation on new motor. Replace all parts in reverse order, restore gas and electric, turn on and test.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
Remove oven bottoms Removed burners Remove igniters Pull out oven removed back disconnect wiring Installed new parts on burner made wiring hook ups Installed oven back and oven bottoms Tested and both work Took so long because I’m 75 years old Thanks for the proper parts
