This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
This gas range oven igniter is compatible with various models of LG gas ranges. It is made up of the igniter element, wire harness, connector and mounting bracket. The igniter is responsible for gener...
This clear inner glass lets you see inside your LG oven while keeping the heat in. If your oven glass is cracked or chipped, replacing it helps restore energy efficiency and safe cooking. It’s made to...
Upgrade your oven with this durable gliding shelf rack, designed to provide a stable surface for baking, roasting, and broiling. Its smooth sliding design makes it easy to insert and remove dishes, of...
This control board helps your oven heat properly and keeps the display working as it should. If your oven isn’t heating, shows error codes, or the controls aren’t responding, this part might be the fi...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Holly
November 27, 2024
Oven temp not accurate. Set for 350 get up to 250 or 375. Already replaced board & sensor
For model number LRG3193BD
Hello Holly, thank you for your question. It may be an issue with the Igniter PS3535362. If it reads 15° F higher or lower than it should when it reaches the 350° F level, it may need calibration. We hope this helps.
Oven gets up to temp but then drops to roughly 180 degrees and will not go above. I have replaced thermostats and no change.
Control board works as it should. Buttons have no flaws when setting temps or settings
For model number LRG3193BD
Hello Blake, thank you for getting in touch. When a gas oven reaches initial preheat temperature but then drops and cannot recover, the igniter is glowing on subsequent cycles but the gas valve is not opening. This shows the igniter is weak, which can not open the gas valve and will need to be replaced to fix the issue. The igniter for your model is part number PS3535362. We hope this helps.
Took off the oven door then took out the racks and two screws in the oven bottom and removed it . Then removed the heat deflector. Then un plugged the old igniter and removed the burner to make it easier to remove the old igniter. Then installed the new igniter and reversed the process
Remove oven bottoms Removed burners Remove igniters Pull out oven removed back disconnect wiring Installed new parts on burner made wiring hook ups Installed oven back and oven bottoms Tested and both work Took so long because I’m 75 years old Thanks for the proper parts
As soon as my husband put it in the oven, the very thin prongs broke. There was no guard on either side of the prongs for protection like the one that had been in there. Very costly to us of $185 with no fix. Very disappointed in that ignitor. It would have been an easy fix. Had replaced one previously but it only lasted 6 months. Now we have a new stove
