Looking for a way to restore your LG refrigerator to prime condition? Our genuine LG Basket Assembly, Door might just be what you need. Made specifically for select LG fridge models, this sturdy and e...
Looking to boost your refrigerator's performance? This LG Crisper Drawer is just what you need! Specifically crafted for your LG refrigerator, it's designed to keep your fruits and vegetables wonderfu...
Looking to simplify your fridge organization? We can help! Our LG Refrigerator Deli Drawer Tray Assembly isn't just any part'it's a genuine OEM replacement made specifically for select LG refrigerator...
This is a genuine replacement switch. It is a push button style switch that is designed for use in your refrigerator. When the door of your appliance is opened the switch is released, and the light co...
This cover support reinforces and stabilizes protective panels or covers during operation. Proper support helps maintain alignment and durability. Replacing a damaged support restores structural integrity.
This door stopper helps limit door movement to prevent overextension. Designed for durability and precise positioning, it supports controlled operation and long-term reliability.
This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit...
We know how inconvenient it can be when a minor issue affects the functioning of your LG refrigerator, so allow us to present the LG Refrigerator Light Lens Cover. Designed to secure the light bulb in...
$33.23
In Stock
Questions And Answers for LRFC22760SB
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
(1) Gasket holder is quite simple. Remove snap-on trim to expose gasket. Identify upper and lower clips (white 1" long) that hold gasket holder into frame of fridge door. Gently pry out / remove with flat-headed screwdriver. Gasket holder will slide out frpm the gasket. Replace - make sure you get the cam facing the correct way at the top of the holder. This is a pretty easy repair, 20 minutes beginning to end. (2) RHS light switch failed - replaced both -- door hinge cap removes w/ a single appliance screw - switches are plug-in to the wiring assembly, and snap into place in the hinge cap.
1. Go behind refrigerator and unplug electrical cord and turn off water supply.
2. In freezer locate electrical plug for ice maker. It has two tabs on the left and right side of it. Lift the tabs and pull the plug to disconnect it.
3. Remove the three screws, 2 on top and 1 on bottom of ice maker You can actually leave the screws in place if you loosen them sufficiently and lift the ice maker off of the screws and washers.
4. Install the new ice maker using the screws and plastic washers to secure it.
5. Plug the electrical connector for ice maker into the receptacle. Note: The plug only goes one way and is keyed with different shaped plugs and holes. The wires on my plug naturally fell upside down so I had to turn the plug 180 degrees to make it fit in the slot.
6. Turn on water and check for leaks.
7. Plug back in refrigerator and you should have ice in less than 12 hours.
