This temperature sensor, also referred to as a thermistor, is a genuine replacement component compatible with various appliance models. It works in coordination with the control board to monitor inter...
Is your LG range oven stove not heating quite like it used to? The Radiant Surface Element could be just what you need. This genuine LG part is specifically designed to provide heat directly to your r...
Are you having trouble with your LG Range? If your settings for temperature and time are acting up, you may need this LG Display Power Control Board. This essential, original OEM part is specifically ...
We understand how important it is to keep your cooking experience smooth and convenient. Our LG Carbon Heater is truly an exceptional product designed with you in mind. If you own an LG range model, t...
Do you have an LG range that's not heating as it should? Our replacement part can solve your problem. This LG OEM part uses radiant heating technology to directly heat your range's cooking area. It's ...
Dropped a hammer on the range while removing a ceiling light. Viewed a How-To video on Google. Ordered the needed parts. Followed the steps from the How-To video. Reinstall was a bit tricky by myself - could have used an extra set of hands. I have a few words of caution: 1) Put something between the range top and range - like a sheet or drop cloth - to prevent a dropped screw from falling into a crevice in the stove. I dropped a screw and was unable to retrieve it, even with a magnet. 2) Makes sure you remove all bumpers, screws, clips, etc. from the item being replaced and put them on the new item if the new item does not come with replacement bumpers, screws, etc.
Go onto youtube, such as https://www.youtube.com/watch?v=-ITkrwhDNMQ and watch similar videos for DYI. The process is very similar to other models.
Once the door is removed, place oven door on a towel or soft place so it does not scratch the door. Unscrew the screws and make sure you notice where each screw goes, so you know the process of where each screw goes when you re-assemble.
Once the inner cover is removed, remove the insulation, too so you don't damage it. Use Wet/Dry Shop Vac to clean the shattered glass. (WORD OF ADVICE: I did not remove the insulation and the suction of the Shop Vac removed part of the insulation, so now instead of a quick turn around repair turns into a few weeks repair, because the insulation is on back order 10-14 days from the supplier. DON"T MAKE THE SAME MISTAKE!)
Once the glass has been removed, the new inner glass is replaced, begin by re-assemble the oven door with the correct screws and attached the oven door to the range.
Looked at schematic to follow circuitry. Checked online for advice. Most online advice suggested replacing thermostat. Thermostat is not in controlling fan circuit! PCB is only circuit controlling fan on and off. I unplugged fan so as to use rest of range until I received and installed PCB. Works fine now. Note: I have electronics background and can read most circuitry.
