LRE3021ST (FSTLLGA) LG Wall Oven - Overview

Diagrams for LRE3021ST

See every part. Know exactly what you need.

Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Temperature Sensor – Part Number: EBG61305805
$59.35
In Stock
Microwave Thermostat – Part Number: 6930W1A003X
$33.93
In Stock
FOOT – Part Number: 4778W1N001B
$21.95
In Stock
FOOT
Part #4778W1N001B
Range Radiation Heater – Part Number: MEE62385201
$198.03
Special Order
Range Radiation Heater
★★★★★
★★★★★
(3)
Part #MEE62385201
A dual radiant heater supplies heat to a cooking area beneath a glass cooktop. Replacement may be needed when one zone does not warm, only the inner or outer section works, or the element has a visible break. Normal radiant burners cycle on and off, so cycling alone does not prove a failure. Check the control switch and connections first, then match the replacement by full model number, location, size, mounting points, and electrical rating. Disconnect the range at the breaker and confirm the circuit is dead before service. Handle sharp metal edges and the glass top carefully, and return every bracket, shield, and wire to its original position.
Display Power Control Board – Part Number: EBR64624906
$99.03
In Stock
Relay Control Board – Part Number: EBR74164805
$153.93
In Stock
Oven Rack – Part Number: MHL63411403
$124.28
In Stock
BRACKET,HEATER – Part Number: MAZ63310801
$13.15
In Stock
BRACKET,HEATER
Part #MAZ63310801
SWITCH,TACT – Part Number: EBF60663403
$39.55
Special Order
SWITCH,TACT
Part #EBF60663403
HARNESS,SINGLE – Part Number: EAD34822916
$43.95
In Stock
HARNESS,SINGLE
Part #EAD34822916
SLIDER – Part Number: MHS62022201
$49.45
Special Order
SLIDER
Part #MHS62022201
SLIDER – Part Number: MHS62022301
$52.75
In Stock

Common Symptoms of the LRE3021ST

How this model fails, and the parts that fix it.

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Hammer 1, Glass range top and heating element 0
24 of 56 people found this instruction helpful.
  • Richard from CHESAPEAKE, VA
  • Easy
  • 30 - 60 mins
  • Screw drivers
Dropped a hammer on the range while removing a ceiling light. Viewed a How-To video on Google. Ordered the needed parts. Followed the steps from the How-To video. Reinstall was a bit tricky by myself - could have used an extra set of hands. I have a few words of caution:
1) Put something between the range top and range - like a sheet or drop cloth - to prevent a dropped screw from falling into a crevice in the stove. I dropped a screw and was unable to retrieve it, even with a magnet.
2) Makes sure you remove all bumpers, screws, clips, etc. from the item being replaced and put them on the new item if the new item does not come with replacement bumpers, screws, etc.
Was this helpful?
Thank you for voting!
Replace Inner Oven glass because it shattered
18 of 41 people found this instruction helpful.
  • Jeffrey from CERRITOS, CA
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
Go onto youtube, such as https://www.youtube.com/watch?v=-ITkrwhDNMQ and watch similar videos for DYI. The process is very similar to other models.

Once the door is removed, place oven door on a towel or soft place so it does not scratch the door. Unscrew the screws and make sure you notice where each screw goes, so you know the process of where each screw goes when you re-assemble.

Once the inner cover is removed, remove the insulation, too so you don't damage it. Use Wet/Dry Shop Vac to clean the shattered glass. (WORD OF ADVICE: I did not remove the insulation and the suction of the Shop Vac removed part of the insulation, so now instead of a quick turn around repair turns into a few weeks repair, because the insulation is on back order 10-14 days from the supplier. DON"T MAKE THE SAME MISTAKE!)

Once the glass has been removed, the new inner glass is replaced, begin by re-assemble the oven door with the correct screws and attached the oven door to the range.

Hope this helps
Was this helpful?
Thank you for voting!
Bottom heat element went out
5 of 14 people found this instruction helpful.
  • Jack from LEXINGTON, KY
  • Really Easy
  • 30 - 60 mins
  • Pliers, Screw drivers
Checked element no reading. Took off back panel and removed element. Took 5 days to get element. Put in new one. Took 20 minutes. Did not have to cut panel as video had shown. It had screws and was easy to get out and put the new one in. The new element was exactly the same as the old one. I checked all elements before ordering. Wa s satisfied with everything but the delivery time
Was this helpful?
Thank you for voting!