LFC22770SW LG Refrigerator - Overview

This genuine refrigerator pantry drawer front cover provides a finished front panel for the pantry or deli drawer while helping keep stored foods organized and protected. Made from durable clear plastic with decorative trim, it serves as a replacement for a cracked, damaged, or worn drawer front and helps maintain smooth drawer operation ...Read moreand a clean appearance inside the refrigerator. The cover measures approximately 17 inches wide, 7 inches high, and 1 inch deep.

Need a new bin for your fridge door? This replacement shelf is perfect for holding drinks, condiments, and small items. It’s made from sturdy, food-safe plastic and fits into the upper left or middle right sections of certain LG and Kenmore refrigerators. It measures about 10.6" x 7.2" x 3.6" and installs easily—just slide it into place. ...Read moreThe look might be slightly different from your old one, but it works just the same.

This door switch is used in refrigerators. It is activated by the closing and opening of the door

This refrigerator door hinge bushing is a durable white plastic component that provides a smooth pivot point for the hinge pin, helping keep the door properly aligned and sealed. It is commonly used to correct doors that sag, make noise, or are difficult to open or close due to a worn or damaged bushing. The bushing installs at the door h...Read moreinge pivot point and typically requires removing the hinge bracket with a 10?mm socket. Color is white, and size and dimensions may vary by refrigerator model.

This ice maker assembly is for refrigerators. This Ice maker assembly contains the complete ice maker and housing. The assembly may include multiple parts; refer to your parts diagram for a complete list of parts included.

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is sugges...Read moreted to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit a defrost cycle only when the temperature is below a preset temperature.

The compressor overload protector attaches to the compressor and shuts off the compressor if the compressor motor draws too much current.

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

This roller assembly supports smooth movement of drawers or internal components, reducing friction and strain. Quiet, easy motion improves usability and helps prevent wear. Replacing a worn roller restores smooth, reliable operation.