This OEM gray Dishwasher Lower Dishrack Wheel Assembly is a plastic kit that allows the rack to slide in and out of the dishwasher easily. If it breaks or becomes damaged. sliding will feel difficult....
Sold individually. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher from moving, shaking, or tilting forward.
The tine pivot clip, also known as the tine row pivot, is used in dishwashers and is located in the upper dishrack. At around 3 inches in length, the clip is used to keep the tine row in place in the ...
This manufacturer-approved Rack Stop Clip is a gray plastic part which can be installed with a screwdriver. Measuring slightly over an inch in length, it prevents the rack from sliding too far and fal...
Also known as rack adjuster. Sold individually.
This is an original part from KitchenAid, Kenmore, Whirlpool, Jenn-Air, and Maytag for use with Dishwashers. The dishrack adjuster arm positioner clip...
This part is the replacement door seal for your dishwasher. It is approximately 22 inches long and 2 inches wide. This door seal is made of gray plastic and is found at the bottom the dishwasher. The ...
The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.
$283.73
In Stock
Questions And Answers for KUDS35FXSS8
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Gordon
December 20, 2023
Wheel broke on the wheel assembly. Tried to order it but no longer available. P/N PS11722152. There must be a replacement. Let me know what to do please. Gordon. Thank you.
For model number KUDS35FXSS8
Hi Gordon,
Thank you for your question. The part number for the replacement wheel assembly is PS3406971. We hope this helps!
I have power to the mother board on kuds35fxss8 KitchenAid dishwasher but don't have power to the control buttons on the top of the door. Any ideas?
For model number KUDS35FXSS8
Hi Daniel,
Thank you for your question. First try turning the power off to the dishwasher to see if this will reset it. If it does not and you still do not have power to the control panel, check the connections between the control panel and the electronic control board to see if they are fitted correctly. If the wiring is fitted correctly, check the electronic control board for any signs of damage, wear or burn marks. If it shows any of these signs, replace it. If the electronic control board is fine, then you will need to replace the control panel. We hope this helps! If you have any questions, please let us know.
Replacement was pretty easy after figuring out how to unsnap/unlock the old pieces. Tools only used to do a little prying and poking, but really aren't needed. Everything either snaps or slides together. Piece of cake
Pulled dishwasher from under counter, attached link to spring, hooked spring back into frame/chassis, threaded link through pulleys, attached other end of link onto door, reinstalled dishwasher under counter. All's well. Note-I purchased an extra link anticipating that the other one will fail. They're cheap enough.
I took the broken basket adjuster off and then attached the new one. It wasn't too difficult, however some removal instructions and re-install instructions( or just a picture supplied) would have been helpful. This isn't an issue for a mechanically inclined person, but would be a challenge for someone that isn't. Thanks.