This part is a replacement glass cooking tray for your microwave. The cooking tray rotates when the microwave is running, and helps your food cook evenly. As it is made of glass, these glass cooking t...
This door interlock switch is for microwaves.
Door interlock switch prevents the microwave from starting when the door is open.
Because the microwave shielding and interlock switches must be pro...
Also known as the coupler. This driver is located directly under the glass turntable, and over the motor. This part helps the glass turntable to rotate.
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Curt
March 6, 2023
My microwave stops working after approximately 10-15 seconds. Message reads, Error Code F7.
I have turned off circuit breaker to the microwave, and turned back on. Tried the microwave again, same message comes up after 10-15 seconds.
What is going on?
Thanks
For model number KHHC2090SSS4
Hello Curt, thank you for contacting us. The error code "F7" indicates that there is an issue with the control board or its associated wiring. To fix this issue, make sure that there are no loose or damaged wires. If the wiring is good, you may need to replace the control board, part number PS11745310, to fix this issue. Good luck with this repair!
There was no "fixing" per say but we still could not use the microwave without the plate. This has to be one of the biggest plates for a microwave. We ordered this through your company and we had it three days later. THREE DAYS! We had expected anywhere from 1-2 weeks. My husband was so impressed he bookmarked your site for future reference. Thank you for being so efficient and prompt. The glass turntable fit like a glove! Sincerely, Mark and Lia Hammond
By pulling the filter screens units down and out with a pair of pliers I had access to the surface lights. Pulled the lights out of their sockets and replaced the bulbs. Real easy. Since the filter units were out, replaced the filters and reinstalled the filter units. The whole operation took less than 15 minutes.
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave.