This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker whe...
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
This part is a replacement flipper or emitter cover for your refrigerator. It is made of white plastic and is approximately 3 inches by 2 inches. The flipper shields the emitter control board and hous...
This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports ...
This part is a replacement refrigerator drive shaft seal for your refrigerator. The drive shaft seal protects the auger motor from water and condensation that may leak down the drive shaft from the ic...
This motor is used to activate the blades to crush the ice for dispensing.
$300.97
In Stock
Questions And Answers for KBSD602ESS01
Ask our experts a question about this model and we'll get back to you as soon as possible!
6 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Yung
February 6, 2020
KitchenAid model kbsd602ess01, freezer light does not work, i can not find the freezer door light switch, please help.
For model number KBSD602ESS01
Hello, Thank you for your question. Your Light switch PartSelect Number PS11740432 is located on the left side of the inside of the freezer, where the door hits. We hope this helps.
Was this helpful?
Thank you for voting!
Bill
January 5, 2023
Water leaks onto floor after using water dispenser, Ice maker works fine with no leaks. What could be the cause and how do I fix?
For model number KBSD602ESS01
Hello Bill, thank you for your question. Water leaks often are the result of leaky water supply lines, Water Tube Connector PS11740187 and/or the inlet valve PS12578871. Thank you and have a great day.
The lights on the freezer side are dim, where as the lights on the refrigerator are okay?
For model number KBSD602ESS01
Hello Mike, Thank you for writing. This could be an issue with the LED Light in the Freezer Section. We also suggest checking the writing to make sure there are no loose connections before replacing the Light. We hope this helps!
At first the dispenser wasn’t working and the ice maker was making only a few small cubes at a time, while it dumped okay, the refill time was only 1 second. Then the dispenser had no power and the ice maker continued to make 1-2 small cubes. 6 days later, everything was working perfectly. Two weeks later the ice maker would dump then refill for @7 seconds(normal time) but it would refill AGAIN in a minute and AGAIN so I shut off the water. Even with the ice maker switch turned off, I could hear the ice maker try to refill. What is going on?
For model number KBSD602ESS01
Hello Sid, thank you for reaching out. According to our research the Emitter/Receiver Boards part number PS10064583 could be what is causing the issue. We hope this helps.
Was this helpful?
Thank you for voting!
Steven
December 6, 2023
Water leaks near bottom left ( freezer) side but only when dispensing water. Leak appears near the leveling device. water appears to be coming from harness that connects to the door bottom.. Local service guy says we need a wThanks !hole new door for $ 2400. Can this be repaired in any othe way?
For model number KBSD602ESS01
Hello Steven, thank you for the question. Disconnect the water line at the coupler below the door hinge, then put your finger over the dispenser spout and blow through the water line. If you have an air leak, you have a leak in the water line. The door liner is foamed in so condensation is unlikely. If there is no leak, you will need to replace the door, part number PS11727674. We hope this information helps!
First I shut the water off to the refrigerator.then i pushed the big button in the middle of the grille below the refrigerator door. pulled out the old filter, took the front cap off the old filter put it on the new filter. took the two red caps off the new filter. pushed the filter in till it locked in place. all done! Turned the back on.
First, I tested the ice maker "switch" that actually just covers the beam that regulates the ice maker. In the "off" position, it still made ice. Then, I removed the three screws on the cover over the transmitter and disconnected the circuit board at the wire connector. It stopped. After ordering and receiving the new transmitter and receiver boards, I replaced both boards. They are located on either side of the freezer compartment under panels held in place by three screws. Probably saved 150 to 200 bucks.