Models
>
JVM1860S
JVM1860S General Electric Microwave - Overview
Models starting with JVM1860S
Click on the best match to narrow your results.
- JVM1860S General Electric Microwave (GE Microwave Model JVM1860S Parts)
- JVM1860SD001 General Electric Microwave (Counter Top)
- JVM1860SD002 General Electric Microwave (Counter Top)
- JVM1860SDC01 General Electric Microwave
- JVM1860SDC02 General Electric Microwave
- JVM1860SF001 General Electric Microwave (Counter Top)
- JVM1860SF02 General Electric Microwave (Counter Top)
Keep searches simple, eg. "belt" or "pump".
Halogen Light Bulb - 120V 20W
PartSelect #: PS2351821
Manufacturer #: WB25X10019
This halogen light bulb is a replacement part for the bulb behind the top grill in your microwave. It is sold individually.
$28.25
Special Order
Grease Filter
PartSelect #: PS227998
Manufacturer #: WB06X10288
This metallic vent hood filter collects grease particles in the air from cooking. This part is sold individually.
No Longer Available
FUSE
PartSelect #: PS1481237
Manufacturer #: WB27X10928
This ceramic microwave fuse is just over an inch in length. It is white in the center, and metal on both ends. This is a 20-amp fuse, and is used to power your microwave. If the touch pad on the micro...
$16.70
Special Order
Drive Motor
PartSelect #: PS237772
Manufacturer #: WB26X10038
This motor rotates the glass turntable in the microwave and accepts a D-shaped shaft.
$92.94
Special Order
Flat Cab Mounting Bolt
PartSelect #: PS651196
Manufacturer #: WB01X10180
This part is the replacement flat cab mounting bolt for your microwave. The bolt is approximately 4 inches long. It is designed to hold the microwave in place in your cabinet. The main reason to repla...
$13.88
Special Order
Halogen Light Bulb
PartSelect #: PS651484
Manufacturer #: WB36X10213
This halogen light bulb is an inch and a half long. Carrying 120 volts and 20 watts, it is used with some microwave ovens.
$27.66
Special Order
Glass Turntable Coupler
PartSelect #: PS227859
Manufacturer #: WB06X10144
This part accepts a D-shaped motor shaft.
$23.68
Special Order
Charcoal Filter
PartSelect #: PS224009
Manufacturer #: WB02X10733
NOTE: The charcoal filter cannot be cleaned. It must be replaced. This metallic vent hood filter collects grease particles in the air from cooking.
$146.58
Special Order
Common Symptoms of models starting with JVM1860S
[Viewing 7 of 7]Won’t turn on
Fixed by
these parts
these parts
Show All
No heat
Fixed by
these parts
these parts
Show All
Tray won’t turn
Fixed by
these parts
these parts
Show All
Doesn’t shut off
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
Noisy
Fixed by
these parts
these parts
Show All
Door not closing properly
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Microwave completely stopped working
Turned out the issue was easily solved by replacing a single, inexpensive fuse.
First off, UNPLUG THE MICROWAVE.
The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
First off, UNPLUG THE MICROWAVE.
The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove another screw that holds a small metal grill in place. Removing the small metal grill is probably the toughest part of this repair. You kind of have to rock it back and forth a bit to get it to release. Once that's off, you can get to the fuse. I removed the burnt out one with a pair of needle nose pliers. I also put a small piece of cardboard under the fuse when I did this so I didn't accidentally drop it into the innards of the microwave. I did the same thing when I replaced the new fuse. I then plugged the appliance back in and made sure it worked. Once that was confirmed, I replaced both grills.
Parts Used:
-
Kim from Cliffside Park, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
955 of 1232 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dirty filter - replacement filter installed
-
Laura from Sugar Grove, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
537 of 612 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
turntable made a loud noise
First I unscrewed the screws that were holding the panel underneath. Then I removed the panel and removed the screws that held the turntable motor in place. Then replaced the old motor with the new and screwed everything back into place.
Parts Used:
-
Dianne from Westminster, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
374 of 380 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!