JGP3036SL2SS General Electric Cooktop - Instructions

A rubber grate foot on my range top had worn out. I pulled the worn foot out and installed the new grate foot with no tools or accessories. Good as new! Now I don't have to worry about the grate scraping my range top and scratching the paint. I also ordered extras so I won't have to wait if another wears out.

New burner cap replaced old; just placed over burner; no tools required.

One suggestion: burner cap should have been shipped with thicker bubble protection (easy to do). It was minimally wrapped and placed in a thin, bubble envelope, risking damage in shipping process. Luckily, the burner arrived in tact and usable.

I was pretty upset as the grate wobbled, so I went on line and looked for GE Profile parts. To my amazement, I found the little rubber feet quite easily, and within 2 days they were here at my home. I simply had to stick them in the holes; however, I noted that they did not fit real tight, so I removed them and shot a little glue on them, and they have been in place ever since. Thanks to you guys, I am a happy camper now!!!

The following are steps in replacing a burner electrode for GE Profile Cook Top Model PGP7030DL1BB
1. Shut off gas and unplug electrical plug
2. Remove all stove grates and turn on knobs
3. Remove all burner covers
4. Remove all screws [three for each burner]
5. Remove two screws near front by removing rubber grate grommets
6. Carefully Lift off stove cover and set aside
7. Remove shield near back of stove top. This exposes all burner wires
8. Remove electrode to burner which does not lite by sliding out clip at bottom of electrode—note color code of wire and replace with same. Change one electrode at a time to insure wire color code is correct.
9. Reassemble in reverse order of steps 1-8

HAVE A NICE DAY

Just lifted old burner off with my fingers and replaced with the new one. What needs to be focused on here is the fact that Part Select has such a complete line of parts rather than the difficulty in the install.

Inserted the grate foot into the spot provided; after consulting the parts manuel to insure I was using the proper procedure.

I do use silicone to help hold the foot but it still won't hold

Replaced worn or missing Grate Foot with new ones. Took less than 5 minutes.

took burner off installed new one thank you for fast shipping

It only required placing the new burner in the proper location.

I got really great customer service on finally getting the right part. It came really fast it fit perfect but the cap is a high gloss black instead of a flat black. I will need to call customer service again to see if they can the correct color this time.
Otherwise everything was great!

Cut off approx. 1/8" in length for correct fit.

I had to drill the hole to a larger size to enable the foot to fit.

there were no grate pads so it was easy to add them.

Nothing technical.

Used scribe to remove grate foot plug still in grate inserted new foot.