This grease filter is almost fourteen inches long and almost twelve inches wide. This filter is intended for use with some downdraft cooktops and ranges.
$49.53
In Stock
Order within the next 7 hrs and your part ships today!
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.51
In Stock
Order within the next 7 hrs and your part ships today!
This surface burner head is for ranges.
Surface burner head distributes the gas through holes or slots to create an even flame across the cooking area.
Shut off the gas supply and unplug the ran...
$202.21
In Stock
Order within the next 7 hrs and your part ships today!
This is the replacement brass seal for your range or cooktop. It is made of brass and is approximately 1 inch in diameter. This part may also be known as the surface burner orifice holder seal. It pre...
$10.18
In Stock
Order within the next 7 hrs and your part ships today!
This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system.
$118.15
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for JGD8348CDP
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bruce
January 19, 2020
The igniter is not working. Questions: How do I clean igniter? How do I replace igniter?
For model number JGD8348CDP
Hello and thank you for writing.
Clean the gas stove igniter and burner holes if the burner won't light. Brush the igniter with a stiff toothbrush to remove gunk. Clean out the gas stove burner holes with a needle.
We would need to clarify which ignitor you would want to change so we can give you the right instructions as they are slightly different for each of the ignitors. We are looking forward to your reply, please always notate the model number. Thank you.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Orazio
December 2, 2023
No repairs needed just want the burner and grate to replace existing grill top as I not use the grill please let me know thanks
For model number JGD8348CDP
Hello Orazio, thank you for reaching out. If you are looking to replace the grill with a burner, you will need to order the burner cartridge assembly. The part number is PS2162200. If you need help placing an order, customer service is open 7 days a week!
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt had built up around burner to pan connection.I used my oil filter wrench to turn slightly the burner to remove it from the pan to clean.Reassembled in reverse order.