This part is the replacement wave guide cover for your microwave. It is gray in color and is approximately 3 ½ inches long and 5 inches wide. It has two small tabs at the top that allow it to lock int...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Mike
January 6, 2020
When i press the open button it blows the circuit breaker
For model number JES1288SH02
Hello Mike and thank you for writing.
It certainly sounds like it could be a faulty switch PS237415, you should check for signs of damage, and replace if necessary. We hope this helps. Please contact us anytime if you require further assistance.
After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece. Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection. Job was complete after reinstalling the cover.
Microwave now working with new lamp lighting when in use.
Continuity checks showed the flame sensor was open. Schematic notes it opens at 217 degrees and closes at 30 degrees. Removed sensor and placed in freezer for twenty minutes. Tested sensor and it was now closed, reinstalled and microwave worked normally. Ordered new sensor in case the original is operating at too low a temperature.