The roller glide in your microwave rests under the microwave plate, and allows it to rotate when the microwave is running. It is a round plastic ring with 3 wheels spaced out around the perimeter. If ...
This part is used to generate microwave energy/heat.
No Longer Available
Questions And Answers for JE2160SF04
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Judith
December 12, 2019
When i push a number it does not work all of a sudden sometime some of them do and others do not.
For model number JE2160SF04
Hello Judith, thank you for writing. You will want to replace the Control Panel Sub Assembly, part number PS2321486 for your model microwave. Good luck with your repair!
Was this helpful?
Thank you for voting!
Judith
December 12, 2019
Pads don't work
For model number JE2160SF04
Hello Judith, thank you for writing. You will want to replace the Control Panel Sub Assembly, part number PS2321486 for your model microwave. Good luck with your repair!
Was this helpful?
Thank you for voting!
Peter
June 6, 2023
my microwave oven is working but has not heat. please tell me what parts need to replace to get the heat.
For model number JE2160SF04
Hi Peter, thank you for the great question. Our research shows that when your model has no heat it is the magnetron, part number PS953838. We hope this helps.
After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece. Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection. Job was complete after reinstalling the cover.
Microwave now working with new lamp lighting when in use.
First I ordered and replaced the diode. That did not help. Then I ordered both the magnetron and the thermostat magnetron because I didn't know what I was doing. After I replaced those, it still wouldn't heat. So I called an electrician. He noticed I had knocked a wire loose. I connected it and the microwave worked. I reconnected the old magnetron, just to test it. It didn't work. Then I put the new one back in. It's working just fine now! It took quite a while to put everything back in place because it was a built-in. But it was a lot cheaper than getting a new microwave, even with the cost of a repair man to show me I had a loose wire!
First, I read the PartsSelect DIY report by Linda, Warsaw, IN. With confidence, I purchased the magnetron. Upon receipt, I took the built-in microwave out of the cabinet, set the unit on the kitchen floor, and was stopped cold by the Safety Torx nuts on the reverse of the unit. Borrowing the right wrench allowed the 20 minute start-to-finish part changeout and reinstallation of the unit in the cabinet to proceed. The old magnetron was the defective part. Discovery of the 10-year Parts-Only warranty on the less than 10-year old unit was insufficinet to guide me to take the unit in for their Labor bill to repair. New part in hand, it just was that easy - and assumed to be no less expensive.
