J-724 (1) Porter Cable Band Saw - Overview

This is an authentic manufacturer sourced replacement brush cap. It is specially designed for Porter Cable band saws and routers. The brush cap is used to secure the carbon brush in the holder. This item is made out of black plastic and it is sold individually. You will need a flat-head screwdriver to install or remove this brush cap.

It is a genuine OEM supplied replacement chain that is specially designed for use with band saws. The purpose of this chain is to rotate the drive pulley, make sure to check appropriate diagram for correct location and use of this part. Over time the chain may wear down or stretch eventually requiring replacement. It is made of high-quality steel and it is sold individually.

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

The guard attaches to the housing. This is an authentic Porter Cable replacement part that is sourced from the original manufacturer for use with band saws. This item is made of metal and is sold individually. If this part becomes broken it will need to be replaced and may require a screwdriver during the installation.

This is a genuine OEM sourced high quality carbon brush, not an aftermarket imitation. It is specially designed for Porter Cable band saws. This item includes (1) carbon brush with a spring and a lead wire attached. Please not the brush holder and the brush cap are both sold separately. It is advised to replace both brushes at the same ty...Read morepe. Replacing this carbon brush is a very easy task that should only require a flat-head screwdriver. • Make sure the tool is unplugged first • Remove the brush cap from the housing • Take out the old brush • Secure the new brush in the holder • Reattach the brush cap and test the tool

This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 10 Feet Long

The bearing is made of metal and attaches to the jackshaft carri. This item is available individually. This is an authentic OEM part for use in Porter Cable sanders and saws. A screwdriver may be required to replace this part. It will need to be replaced if it becomes worn down or broken.

This is an authentic ball bearing sourced from original equipment manufacturer. It is designed for use on band saws and profile sanders. This bearing is used in different locations depending on a tool. Please check appropriate models diagrams to ensure correct application. Bearings are helps to support and sping rotating parts. Since bear...Read moreings are under constant pressure, over time they would wear out requiring replacement. Includes one (1) sealed metal bearing. Included in part number 694978 Guide Hardware

This needle roller style bearing is an OEM part. It is commonly found in band saws produced by Porter Cable, DeWALT, and Black & Decker. Bearings are used to diminish friction between moving parts while also securing rotational angle. They need replacing fairly often because of this high wear role. Sold separately.

An authentic manufacturer-sourced washer which is specially produced for use with power tools. This replacement washer has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for the correct location and use of this hardware. It is a high-quality item which is made of durable metal and it is sold individually.

This is a genuine replacement part sourced directly from the manufacturer. The knob is commonly found in band saws from Porter Cable, DeWALT, and Black & Decker. This part is made of high-quality plastic, and is generally used to adjust the tension shaft in the frame assembly. This item is sold as an individual replacement part.