If your dishwasher door will not close, is noisy when operating, or the dishes are not cleaning properly, you might need to replace one or more of the wheels. Each wheel and axle are made of plastic a...
The Rack Slide End Cap is a white one-inch plastic part which replaces the end cap for your dishwasher rack, preventing your rack from sliding too far. If you find the dish rack is causing the door to...
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
The hinge link on your dishwasher connects the spring to the dishwasher door hinge. If the hinge link becomes cracked or damaged, you may not be able to shut or lock your dishwasher door properly. In ...
This coupler, also known as a hose connector, is made of white plastic and is about one inch in height, and just over one inch in length. Replacing the coupler is a fairly easy repair. The hardest par...
This OEM-compatible screw is designed for use with many GE dishwashers. Measuring 8-16 HXW and 1/2" in length, this stainless steel screw secures the middle spray arm hub to the upper rack assembly, e...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Frank
December 2, 2019
How do i remove the filter it has a drain going into the middle of the filter cant lift the filter out
For model number HDA2100V35WW
Hello Frank,
Thank you for your question. You will need to remove the bottom spray arm to remove the filter. On the side of the base of the arm there is a tab you will need to pry outwards a bit with a small flat head screw driver to release the spray arm. It is off to the side on the back side so it is not easily seen. You may have to feel around to locate the tab. Hope this helps!
the water does not drain. I have checked for restrictions throughout the system including the line going to the garborator. I have removed and cleaned out the interior filters of the unit. The clinoid appears to work, however, water remains. I am wondering if the clinoid although it moves is not working. Any suggestions before I order the clinoid unit? Thanks
For model number HDA2100V35WW
Hello Brian, thank you for getting in touch. According to our research, we would recommend checking the drain solenoid carefully for any fault. If the drain solenoid is completely fine, then the issue is most probably with the drain pump. The drain pump comes along with the pump and motor assembly, part number PS3486941. You may need to replace it to solve the problem. Glad to be of assistance!
Unsnapped clip,and moved it 90 degrees. Slip wheel and clip off. Installed clip on new wheel. replaced new wheel. The wheel did not come with a new clip and was not suggested on the parts list. The existing clip was still OK but if it was not, I would have had to order a clip and wait. All in all, a good experience.
The wheels came with a clip on part that clipped to the rack and the wheel snapped into that clip. I am a woman and it was easy for me to do. Thanks to Parts Select for being an easy to use and navigate site, for quick shipment and for good directions with the parts. Sincerely, Teresa from Alabama.
