Your washer uses 4 tub dampening straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet and are sold individually.
The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably ...
This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you...
This timer dial with compression ring shows you which part of the cycle your washer is in. It is white in color and can be found mounted on the timer shaft. You may need to replace this part if your ...
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
$45.99
Special Order
Questions And Answers for GTWP1800D2WW
Ask our experts a question about this model and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dianna
November 26, 2019
My be top loader was making a loud noise when washing. I replaced the tub dampening straps but now my washer sounds like it's going threw the cycles but nothing is happening. The agitator just sits without moving.
For model number GTWP1800D2WW
Hello Dianna and thanks for writing.
You should check the following part for damage or misalignment
Agitator # PS11736866
Coupling # PS1482517
Belt # PS1482278
We hope this helps. Please contact us anytime. Good Luck with your repair.
Hello Teresa,
Thank you for your question. Our sources suggest replacing the drive belt under part PS1482278 for your model to fix the issues. We hope this helps!
Hello Helena,
Thank you for your question. Our sources suggest replacing the drive belt for your model under part PS1482278 to fix the issue. We hope this helps!
I replaced the bearing and bearing washer because it sounded like metal on metal and loud on spin.Now it is still very loud on spin but does not sound like metal on metal and shaking. Any suggestions?
For model number GTWP1800D2WW
Hi John, thank you for your inquiry. We have found that the issue is with the suspension rods and spring assembly. The rear suspension rod assembly is part number PS3654191. The front suspension rod assembly is part number PS3654190. We hope this solves your problem!
I spoke to a very nice young ladie who took my order and I received my order within two days. I pull the clasp off of the old knob and replace the knob and the clasp with the new part and it now works great. Thank you for helping me find the part I needed.
After removing frt panel which prys off I checked for anything obvious like a loose belt. Then I jiggled the magnet switch located on the inside of the loading cover. I saw the machine start agitating the it stopped again when I stopped touching it. I ordered the new part and spliced it in with the wire crip tool. Now the machine is A ok.