This suspension rod and spring assembly is a manufacturer-approved replacement part designed to stabilize the washer tub during operation. Positioned on the left side of the machine, it is one of four...
Having trouble with your GE washer? Our Nut Hub could be just the solution you need. This little device has a big job ? it tightly secures your washer hub to the gear case shaft. Its accuracy helps yo...
This large white washer lid is a genuine OEM replacement for top-load washing machines, designed to cover the drum securely, prevent water splashing, and ensure safe operation during wash cycles. Buil...
Struggling with a faulty washer? It might just need some love with a simple part replacement. Our GE Washer Hub, often known as the hub nut, could be the perfect fix you need. This tough, reliable lit...
Drain all the water out of the tub with a shop vac Remove rear drain hose and drained rest of water into a bucket Remove small rear panel (bottom left hand corner) where the drain hose connects Tipped washer up about 45 degrees to get underneath it - Supported it with a few paint cans Remove internal drain hose/clamps from pump - w/ pliers Remove belt cover (gray plastic) with socket - 3 bolts Remove wire assembly plug from socket Remove old drain pump with socket - 3 bolts Install new drain pump - 3 bolts - plug wire assembly into socket Reinstall belt cover - 3 bolts Reinstall hose to drain pump (note panel will be inside washer) Feed drain hose panel through hole and reinstall - 1 nut Re attached drain hose to exterior drain plug You are done !
Very simple to repair. Be sure to drain the tub outside or into the sump pump then lay the washer on its side. The pump is right there on the bottom of the basket with 3 bolts. You will also need to remove the belt cover to get to the plug. So simple and saves you hundreds off repair man prices.
