This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-r...
This is a duct felt seal for a dryer. The duct felt seal allows the front-load dryer drum to glide smoothly on the front panel. Your dryer will not function properly if the drum felt seal is compromis...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Javier
March 10, 2023
Knob automatic control works only for a couple minuts and shutt off,
Only works on the time dry position and I adjust the time manualy
For model number GTD75ECSL1WS
Hi Javier, thank you for reaching out. According to our research on this model, the issue seems to be with the sensor assembly, part number PS12342983, or the main control board, part number PS12722950. We would suggest checking both these components for continuity using a multimeter. A defective sensor might not read the moisture level properly, and give improper instructions to the control board. Or in other cases, the control board might itself be malfunctioning. We hope this information helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bryon
August 5, 2023
Dryer made a noise and stopped
Everything turns on and lights up but when I press start just a clicking noise behind control panel
For model number GTD75ECSL1WS
Hello Bryon, thank you for your inquiry. According to our research, the issue is most likely with the electronic control board. We recommend you replace the electronic control board, part number PS12722950, to fix the issue. Before replacing the control board, make sure door is properly locked. We hope this solves your problem!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Removed the front Dryer panel. Left drum in place and lifted it up slightly to get access to motor drive. Slipped belt in place and put panel back on. This was a first attempt ever at fixing an appliance and it was no big deal.
I had to take most of the dryer apart because there is no rear access to the motor. It turned out to be easy to dissasembel the dryer. The only problem that I had was that I could not figure out how to route the belt around the motor and the idol pullies. I could not find anywhere that gave instructions on how to properly tension the belt. I finally figured out that the idoler pulley needs to be locked in place on the right side of the engie mount. Then the belt needs to be routed over idoler pulley and under the motor pulley. Finally release the idoler pully from the locked postion to put tension on the belt. It really turned out to be pretty easy.
Pryed off the top with a flat head screwdriver and removed the 2 screws holding the front panel to the sides. Then lifted the front panel off of the bottom brackets. Belt fit perfectly and followed the provided instructions to loop it around the motor and pulley. PartSelect got the part to me within a couple of days and the repair was a snap.
