GR-L28ANSPP LG Refrigerator - Overview

If your fridge doors aren’t sealing properly or you’re noticing cold air escaping, this front plate assembly might be the fix. Also called a mullion or flipper, it fits between the French doors to keep the cold in and your food fresh. Made for select LG and Kenmore models, it’s built from sturdy plastic and helps your fridge run more efficiently. Just check your model number to make sure it’s the right fit.

This refrigerator water filter replacement is for 2010 LG refrigerators that have either forward French doors or are the four-door dispensing models. This filter is designed to minimize impurities that can cause ill-tasting water or an unpleasant smell. It reduces sediment, dirt, rust, limescale, sand, and many other contaminants that can...Read more be harmful to your health and the life of your appliance. This filter should be replaced every 6 months or 200 gallons to ensure top quality performance. To remove your unwanted filter, press the push button to open the filter cover (water may spill from the hole), pull out the old cartridge in a downward motion. To install the new filter, make it so the ears are in the horizontal position and push the new cartridge into the housing until it stops. Push the filter upward until it is secure. Click the cover to lock it in place. Run water for approximately 5 minutes to prep the filter for use, and discard water. Reset the “filter reset” button if applicable.

This spring is located on the mullion, or door flap, of your fridge. This spring is sourced from the genuine OEM manufacturer for various refrigerator models. It measures about 1.5 inches in total length, and is made entirely out of metal.

This includes the primary and secondary valves along with the wire harness.

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is sugges...Read moreted to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

This valve helps your fridge deliver water to the ice maker and dispenser. If you’re not getting ice, the dispenser isn’t working, or you hear strange noises, this part might be the fix. It’s easy to install—just make sure it fits your model and turn off the power and water before replacing.

The water reservoir holds the water for the water dispenser as the water chills.

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

Tired of your fridge not making ice? This LG ice maker kit could be the fix. It freezes water into cubes and uses a built-in heater and thermostat to pop them out when they’re ready. It’s a genuine part made to fit LG models and can make up to 14 cubes at a time. Easy to install and built to last—just check your fridge model before ordering!

This genuine refrigerator ice storage container holds and stores ice produced by the ice maker until it is ready to be dispensed. Featuring an integrated auger and dispensing mechanism, it helps deliver ice smoothly through the refrigerator door while keeping ice organized and readily available. Designed as a direct replacement for a dama...Read moreged or worn ice bucket, it can help restore proper ice dispensing performance. The container measures approximately 15 inches long, 8 inches wide, and 7 inches high.