GR-L247TRA LG Refrigerator - Overview

Sections of the GR-L247TRA

[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Refrigerator Door Switch – Part Number: 6600JB1010A
Refrigerator Door Switch
★★★★★
★★★★★
(2)
PartSelect #: PS3529268
Manufacturer #: 6600JB1010A
This door switch is used in refrigerators. It is activated by the closing and opening of the door
$46.15
  In Stock
Order within the next 10 hrs and your part ships today!
Ice Tray – Part Number: 3390JA1150A
Ice Tray
PartSelect #: PS3518775
Manufacturer #: 3390JA1150A
This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ...
$16.45
  In Stock
Order within the next 10 hrs and your part ships today!
Refrigerator Water Tube Fitting – Part Number: 4932JA3002A
Refrigerator Water Tube Fitting
PartSelect #: PS3524388
Manufacturer #: 4932JA3002A
The water tube fitting connects lines that supply water to components such as the ice maker and water dispenser.
$35.15
  In Stock
Order within the next 10 hrs and your part ships today!
Water Inlet Valve Assembly – Part Number: 5221JA2006D
Water Inlet Valve Assembly
PartSelect #: PS3527457
Manufacturer #: 5221JA2006D
This water inlet valve has three solenoid valves and push in fittings. When energized this part releases water from the supply line into the ice mold.
$126.14
  In Stock
Order within the next 10 hrs and your part ships today!
Solenoid Assembly – Part Number: 6421JA3001D
Solenoid Assembly
PartSelect #: PS3529153
Manufacturer #: 6421JA3001D
$90.60
  Special Order
CONTROLLER ASSEMBLY – Part Number: ACM73079207
CONTROLLER ASSEMBLY
PartSelect #: PS11707206
Manufacturer #: ACM73079207
Dealing with a faulty appliance? You're in the right place. Our LG Controller Assembly could be the perfect solution for you. This critical replacement part is a genuine OEM item that's specifically d...
$58.25
  Special Order

Common Symptoms of the GR-L247TRA

[Viewing 5 of 5]
Light not working
Fixed by
these parts
Fixing
Show All
Leaking
Fixed by
these parts
Fixing Fixing Fixing
Show All
Not dispensing water
Fixed by
these parts
Fixing
Show All
Ice maker won’t dispense ice
Fixed by
these parts
Fixing
Show All
Ice maker not making ice
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Remove and replace light switch
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
Parts Used:
Refrigerator Door Switch
  • Debbie from Waltham, MA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
45 of 89 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The ice tray had warped and dumped water, which then froze down through the ice bucket and below.
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting.
Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards.
The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.

/Users/grf/Desktop/fridge ice tray.pdf
Parts Used:
Ice Tray
  • George from ATLANTA, GA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
8 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Refrigerator light would not reliably turn on when the door was opened.
Switched the refrigerator circuit breaker to off. Put tape around the switch to prevent scratches. Wedged the putty knife into the right side of the switch and pried up.the switch and connector popped out. Removed the connector from the old switch and connected it to the socket in the new switch. Stuffed the new switch and connector back into its home. Switched on the circuit breaker. Now we have light in the refrigerator with every opening!
Parts Used:
Refrigerator Door Switch
  • William from TUCSON, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!