This OEM ice and water filter fits side-by-side and bottom-freezer GE models. The most common reason you would need to change this part is if you have never updated your model and it is no longer filt...
This part is a replacement filter bypass cap for your refrigerator. If you intend to use an external water filtration system for your refrigerator, the bypass cap will allow you to do so. To use a fil...
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
Note: Therm...
This evaporator fan blade is for your refrigerator, and it circulates air so that the temperature of the fridge is regulated. This model has 3 blades, and is a little more than 4 inches in diameter. I...
This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
JOHN
February 20, 2024
how is the door handle attached
For model number GNE25JGKBFBB
Hi John,
Thank you for your question. According to your owner's manual, Attach refrigerator handle to the mounting fasteners by aligning the slots on the handle with the mounting fasteners. Slide the handle down until it comes to a hard stop. We hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Gordon
July 20, 2021
How do I replace the door gasket?
For model number GNE25JGKBFBB
Hello Gordon, Thank you for the question. Here is a link on replacing Door Gaskets. The Appliance is a different but they will be installed the same way. We hope this helps!
https://www.youtube.com/watch?v=b1CMJ0TNjT0
Was this helpful?
Thank you for voting!
Jeana
December 25, 2023
My ice maker won’t make ice but water comes out of the top fridge spout inside the fridge. Turned the freezer ice maker off for 30 minutes and back on but still won’t work. What do I do
For model number GNE25JGKBFBB
Hi Jeana, thank you for getting in touch. Based on our research, this is usually due to the clogged water filter, part number PS8746144. We would recommend checking the filter to fix the issue. Good luck with your repair!
I went to a GE repair center to explain my problem, the service center reccomended that I have a techinician come out o look at it. $75.00 for the visit and what ever labor and materials wuld cost.
I went on line to see if there were others having this same problem and found that there were many with the same problem.
After reading some of the ways that people found out what was wrong ...it became a matter of three components, the timer, heater or thermostat.
I tried the most common component and the less expensive one first , the thermostat switch I installed it very easily snipping two wires and attaching the news using wire nuts I used the diagram on this website to pinpoint the component and there has not been a problem since.
Unscrew old filter and remove(counterclockwise). Line up arrow on new filter with arrow on connection housing. Turn clockwise till resistance met. Do not overtighten. Follow directions. Simple.