GM-L277UQRY LG Refrigerator - Overview
Sections of the GM-L277UQRY
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Ice Tray
PartSelect #: PS3518775
Manufacturer #: 3390JA1150A
This part is the replacement ice tray for your refrigerator. The tray is made of white plastic and is approximately 9 inches in length, and 3 inches in width. It has the capacity for 8 ice cubes. The ...
$16.45
In Stock
Refrigerator Hinge Assemblylower
PartSelect #: PS3523509
Manufacturer #: 4775JA2113A
$56.05
In Stock
Motor,AC
PartSelect #: PS3523107
Manufacturer #: 4680JB1026H
Keep your refrigerator running at its best with this condenser cooling fan motor. It helps move air across the condenser coils to release heat, so your fridge stays cool and efficient. If you notice y...
$125.16
In Stock
Evaporator Fan Motor
PartSelect #: PS3523328
Manufacturer #: 4681JB1029A
This evaporator fan motor is a replacement drive component designed to circulate air across cooling surfaces. It supports even temperature distribution and is commonly replaced when airflow decreases ...
$110.83
Special Order
Handle Assembly,Refrigerator
PartSelect #: PS3532177
Manufacturer #: AED37082918
$128.47
Special Order
Capacitor,Electric Appliance Film,Radial
PartSelect #: PS3534439
Manufacturer #: J513-00012P
$152.48
Special Order
Common Symptoms of the GM-L277UQRY
[Viewing 4 of 4]Noisy
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Door won’t open or close
Fixed by
these parts
these parts
Show All
Ice maker won’t dispense ice
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The ice tray had warped and dumped water, which then froze down through the ice bucket and below.
To replace the warped tray, I found the service manual (pg. 124 below) which took some interpreting.
Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards.
The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.
/Users/grf/Desktop/fridge ice tray.pdf
Removed the lever. Then removed the assembly by two screws that are forward to the unit and go upwards.
The insulation, sensor, and sensor cover are simply pulled down and off and the unit separated to removed the tray, and then insert the new tray. Proceed in reverse. Takes only a few minutes.
/Users/grf/Desktop/fridge ice tray.pdf
Parts Used:
-
George from ATLANTA, GA
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
8 of 8 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice tray was bent and spilling water onto ice making it freeze
I took the ice out with one screw and took out the old tray the new one slipped right in and I hooked up the little heat strip with one snap works perfect cost $10 I was told by appliance repair tech that I needed to replace the ice maker for $450 saved $440 dollars replacing the bent or warped ice tray
Parts Used:
-
William from Nolensville, TN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!