This guide rail, also known as a drawer slide rail, is a genuine OEM replacement part for the freezer section of your refrigerator. This slide rail supports the storage basket in your freezer, allowin...
This left-side drawer slide is designed for use in select refrigerator-freezer models, supporting the freezer drawer and allowing it to glide smoothly in and out. Made of durable white plastic and mea...
$153.12
In Stock
Order within the next 1 hr and 1 mins and your part ships today!
Looking for a way to restore your LG refrigerator to prime condition? Our genuine LG Basket Assembly, Door might just be what you need. Made specifically for select LG fridge models, this sturdy and e...
$93.73
In Stock
Order within the next 1 hr and 1 mins and your part ships today!
Built from durable, wear resistant material, this cam prevents door sagging and supports long term hinge stability. It helps maintain proper refrigerator function by ensuring the door operates with co...
$44.97
In Stock
Order within the next 1 hr and 1 mins and your part ships today!
This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh ...
$243.17
In Stock
Order within the next 1 hr and 1 mins and your part ships today!
This part is a temperature sensing devise. It senses the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted. It is calibrated to permit...
$75.80
In Stock
Order within the next 1 hr and 1 mins and your part ships today!
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator.
Check YouTube, but no one shows all the details. Need to swap hinges and spring from old retainer to new retainers by removing screw at bottom of hinge, then removing rod with small screwdriver to poke the rod out. I laid the old and new side by side and did swap to ensure proper orientation. Attach cams before sliding gasket retainer back into gasket, I used a few drops of liquid soap as lubricant on the retainer to help it slide in. Very important to ensure the edge of the retainer is tucked behind the door edge or else things will not fit correctly. I did it a few times before I got it right, but didn’t break anything else. Good luck.
